STANDARD SAFETY AND WARNING NOTICE FOR ALL MAREL EQUIPMENT
All persons involved in the use and/or installation of this machinery should be aware of the following instruc
tions.
Failure to follow these instructions or other safety instructions in the manual voids all warranties and may res
ult in malfunction of the machinery, property damage, serious personal injury, or death.
WARNING
The installation and use of this product must comply with all applicable national, state, and local codes.
Turn the electrical power off when working on the machinery. Turn the main electrical breaker, located on the
electrical cabinet, to the OFF position and lock the breaker with a padlock.
Electrical installations and repairs must be performed by a licensed electrician, in accordance with man
ufacturer's specifications and national and local electrical codes.
Operating the machinery without the supplied guards or covers installed is a misuse of the machinery and can
cause a personal hazard.
Do Not
work on any moving parts of the machinery, such as belts, motors, belt tension adjusters, or rollers, without first
disconnecting the electrical power and closing the main air supply valve. Otherwise, a serious personal injury or
death may result.
Do Not
work on electrical or air cabinets without first disconnecting the electrical power, or a serious personal injury or
death may result.
Do Not
make any changes to the emergency stop buttons.
Additional Safety Information
Keep long hair tied back and covered.
•Avoid wearing loose clothing, jewelry, or accessories near moving machine parts. This includes ties, shirtsleeves,
rings, watches, and other loose fitting items.
•Disengage the machinery to avoid moving parts when cleaning and lubricating bearings.
•Avoid moving parts when lubricating with hand-sprayed lubricants.
•Never work without another person in the vicinity.
•Wear safety glasses when doing the following:
- using a hammer to drive pins, riveting, staking, etc.
- drilling, grinding, etc.
- using spring hooks or attached springs.
- soldering, cutting wire, removing steel bands, etc.
- cleaning parts with solvents, spray, or cleaners.
•After cleaning or maintenance, reinstall all safety devices such as guards, shields, signs, and grounding wires.
•Wear ear protection when exposed to noise exceeding 90 dB, such as when using a grinder, band saw or ham
mer.
•Lift items with a straight back, and push up with your leg muscles, to prevent back strain. Do not lift any equip
ment or parts weighing more than 30 kg (60 lb.) without assistance.
•Use only FDA or USDA approved solvents, grease or oils.
