Marstair ECO+ Istruzioni operative
56208004-01
ECO+ Systems
Split Heat Pump Installation & Owners Manual
Thank you for selecting an ECO+ heat pump split system.
To ensure many years satisfactory operation, this owner’s manual should be read carefully before
using the heat pump. After reading, store the manual in a safe place and refer to it for questions on
use.
The ECO+ heat pump is designed for domestic and light commercial applications.
This instruction supersedes
any other instructions found
inside this unit.
2 /20 56208004-01
Contents
Filters 2
Safety Precautions 3
Remote Controller 4
Operating instructions 6
Maintenance 8
Protection 9
Troubleshooting 10
Installation Instructions 11
Filters
Power Sleep
Sleep Indicator
It lights up during the
set sleep function.
Red Power Indicator
It lights up when
power supply is on.
Green Run Indicator
It is on during
operation
Yellow Timer Indicator
It lights up during
the set time
Signal Receives
Receive signal from
the remote controller.
Timer Run
3 /20 56208004-01
Safety Precautions
Notes: 1. For the purpose of innovation and improvement, these products are subject to change without prior notice.
2. The air conditioner is not a toy please keep children away from equipment!
Power supply must be in accordance
with the rating plate requirement.
Failure to comply may result in serious
faults, hazards or fire.
Keep the power supply MCB or fuse
clean. Ensure connections to the MCB
or fuse are secure; failure to do so
ma
y
result in electric shock or fire.
Don’t use the power supply circuit
breaker to turn the unit off. Do not pull
the plug out using the cable.
Do not tangle, pull or stress the power
supply cord as damage may result in
electric shock or fire.
Never insert a stick or similar objects
into the unit. Such actions may lead to
damage to the unit and injury.
It is advisable to direct the airflow away from
occupants and cool the room as a whole.
Always turn the air conditioner off via
the remote controller before turning off
the power.
Should repairs become necessary,
they should only be carried out by
qualified personnel.
Ensure the airflow is directed away
from all heat sources.
Do not touch the operating buttons
when your hands are wet.
Do not put any objects on the outdoor
unit or obstruct the airflow.
The equipment must be earthed
(grounded) in accordance with local
regulations. Qualified personnel only
should carry out electrical wiring.
4 /20 56208004-01
Remote Controller
How to insert batteries
(1) Remove the battery cover by sliding in the direction of the
arrow.
(2) Insert new batteries (2 x AAA) none rechargeable making sure
the polarity is correct
The remote controller will default to Heat Pump mode if no buttons
are pressed for 10 seconds, at which point the ‘Heat’/’Cool’ flashing
will stop.
Alternatively:
Press any button on the remote controller while “Heat” is
indicated to preset the controller for Heat Pump operation.
Notes:
If the remote controller is preset for cooling only, heating commands will
not be possible.
Refit the battery cover by sliding it back into position.
Storing the Remote Controller
The remote controller may be stored on a wall using the holder supplied.
Using the remote controller
To operate the Eco+ heat pump, point the controller at
the receiver in the middle of the unit.
The controller will operate up to 7m away from the unit
if pointed directly at the receiver.
5 /20 56208004-01
Remote Controller
(Picture shown maybe different from remote controller enclosed but all functions are the same)
6 /20 56208004-01
Operating Instructions
With the remote controller pointing towards the air conditioner:
.
•If you don’t like FEEL mode, try changing to HEATING, DRY or COOLING instead.
FEEL mode operation procedure
Note:
There will be a delay when changing
mode during unit operation.
The fan may stop during the changeover
7 /20 56208004-01
Operating Instructions
The timer may be set to start the system operation during your absence, to create comfortable conditions on
your return.
It can also be set to turn the system off after a programmed delay, eg when you go to bed.
Note: After setting the timer, check that the YELLOW TIMER INDICATION light is visible on the indoor unit.
TIMER mode
8 /20 56208004-01
Maintenance
9 /20 56208004-01
Protection
10 /20 56208004-01
Troubleshooting
The following examples may not always be due to a malfunction; please check before calling an
engineer.
Altri manuali per ECO+
1
Indice
Altri manuali Marstair Condizionatore d'aria
Marstair
Marstair CX Series Manuale utente
Marstair
Marstair 526 HL Series Manuale utente
Marstair
Marstair A2LCABINETMATCH Manuale utente
Marstair
Marstair IMPACT 20 Manuale utente
Marstair
Marstair CC 600 Manuale utente
Marstair
Marstair DRC+ 30 Manuale utente
Marstair
Marstair CX Series Manuale utente
Marstair
Marstair A2LSYSTEMATCH SMC 15 Manuale utente
Marstair
Marstair MB Series Manuale utente
Marstair
Marstair ECO+ Manuale utente
Marstair
Marstair 17 Series Manuale utente
Marstair
Marstair CKC 15 1/50 Manuale utente
Marstair
Marstair CC 875 E Manuale utente
Marstair
Marstair DXD(H) 50 Manuale utente
Marstair
Marstair CWW 15 Manuale utente
Marstair
Marstair 537 series Manuale utente
Marstair
Marstair CKC 20 1/50 Manuale utente
Marstair
Marstair CWC(H) 600 L Manuale utente
Marstair
Marstair CWM L 55 Manuale utente
Marstair
Marstair CC 600 GREEN HEAT Manuale utente
