Master Spas Axis Manuale operativo

INSTALLATION & USER GUIDE

Unbox and verify all components are present.

a. 1 qty - Axis Cover

KIT COMPONENTS

SPECIFICATIONS

1. Cover skirt is

approximately 12½"

(measured down

from the top of the

swim spa shell).

2. Bottom of Rotating Lever

Latch is approximately 17" at

lowest adjustable point from

the top of the swim

spa shell.

3. Fully rolled diameter is

approximately 28", based

on a 19' model.

4. Cover locks

measure approximately

7½” (measured down

from the top of

the swim spa shell).

e. 2 qty - X900185 Plastic Pinned

Washers for Rotating

Lever Latch

f. 12 qty - X551350 #8x½"

Screw

j. X900162 #4x¾" PH FH Screw

for Cover Lock*

h. 2 qty - X710701 #10x 1 ½"

SS Screw

*quantity varies

depending on model/size

*number of locks

varies depending

on model/size

b. 2 qty -X900198 Lever

Channels

c. 2 qty - X900185 Top Handle

of Rotating Lever

Latch

d. 2 qty - X900185 Base of

Rotating Lever Latch

g. 4 qty - X717900 #10x2½"

Screw

i. 2 qty - Axis Cover

Dome Labels

4.*

WATCH THE VIDEO:

MasterSpas.com/axis

e. 2 qty - X900185 Plastic Pinned

Washers for Rotating

Lever Latch

CAUTION: Do not grasp the side cover skirt material

to roll or move the cover. Doing so may result in

unwarranted damage such as ripped and torn material.

Only grasp the bottom grey insulating bag and its

handles as shown below. Grabbing and pulling on other

components/parts of the cover to shift or maneuver the

cover will result in unwarranted damage.

g. 4 qty - X717900 #10x2½"

Screw

INSTALLATION

COVER Place cover on one end of the swim spa and

roll open across the swim spa by grasping the bottom

grey insulating bag (Figure 1). Then, grasp the bottom grey

insulating bag and its handles to center the cover on the

swim spa.

FIGURE 1

Cover skirting has been ﬂipped up to expose the

layers of material for illustrative purposes.

LEVER CHANNEL Install Lever Channels (b) to both

8' ends of the swim spa skirting (Figure 2). Center Lever

Channel on the swim spa skirting against the swim

spa shell ﬂange with “L” side up (Figure 3). Use 5 of the

#8x½" screws (f) to mount this. First, install 1 screw

into the channel groove at each end, 1" from the end

(Figure 3). Then, space the remaining 3 screws evenly

across the Lever Channel. Repeat for the opposite end

of the swim spa.

NOTE: If there are vertical trim strips on the skirting

(causing an uneven surface), they will need to be

moved down or trimmed to allow Lever Channel to

be mounted on a ﬂat surface.

INSTALLATION

FIGURE 2

FIGURE 3

WATCH THE VIDEO:

MasterSpas.com/axis

ROTATING LEVER LATCH At the center of the 8'

end of the swim spa, use a level or straight edge to

reference the top of the swim spa shell. Measure down

10" and mark this center point for the top center screw

of the Rotating Lever Latch Base (d). With the arrow

facing up, mount base of Rotating Lever Latch to swim

spa skirting (Figure 4) using 1 #10x1 ½” screw (h) for the

top mounting point. Use 2 #10x2½" screws (g), for the

two lower mounting points on the base (left and right).

The Rotating Lever Latch may mount over a skirt vent

which is normal (if vent prohibits base mounting ﬂush,

simply remove vent when mounting base). Mount

with screws at the lowest point in the slots on the

Rotating Level Latch Base. The slot is present to allow

downward adjustment of the base if necessary later.

Repeat for opposite end. (Continued...)

FIGURE 4

INSTALLATION

Top Center

Screw Point

Using

Side Screw

Points

Using

Cover lever

arm

FIGURE 5

Next, push the top half of the Rotating Lever Latch

with the lever end facing a 3 o’clock position (Figure 5).

Insert the plastic pinned washer (e) into the center

pivot shaft of the Rotating Lever Latch with pins

aligned to the grooves in the shaft. Use 1 #8x½" screw

(f) to attach top half and base of Rotating Lever Latch

together.

INSTALLATION

WATCH THE VIDEO:

MasterSpas.com/axis

Install 1 Axis Cover Dome Label (i) into recessed,

oval area on the Rotating Lever Latch (c) (Figure 6).

Repeat for the opposite end.

SECURING THE COVER Insert cover lever arm

into the Lever Channel installed on the swim spa

skirt (Figure 7 below and Figure 18 on page 13 provide

illustrations for securing the cover). Push in on the

cover lever arm and turn the Rotating Lever Latch to

12 o’clock position to secure the cover lever arm

(Figure 19, page 13).

FIGURE 6

FIGURE 7

Cover skirt is

approximately 12½"

(measured down

from the top of the

swim spa shell).

COVER LOCKS Using provided #4x¾" Phillips Flat

Head Screws (j), mount the cover locks located along

the long sides of the Axis Cover to the swim spa

skirting (Figure 8). These cover locks MUST be attached

and secured when swim spa is not in use. Refer to

cover lock system overview (Figure 9).

*Screw quantity varies by cover model/size. There should be 3

screws per cover lock body.

j.*

FIGURE 8

INSTALLATION

Cover skirting has

been ﬂipped up to

expose cover locks for

illustrative purposes.

WATCH THE VIDEO:

MasterSpas.com/axis

FIGURE 9

Cover locks measure

approximately 7½"

(from the top of the

swim spa shell down).

OPENING THE COVER

ATTENTION:

Be sure to remove any foreign objects such as small sticks,

branches, or other debris from the top of cover before rolling

it open. This prevents damage from occurring and debris from

getting into the swim spa when it is rolled closed again. Tears

or puncture damage caused to the cover by foreign objects

are not covered by the limited warranty.

Unlock and release all cover locks along the long sides of the

cover. Lift up the cover skirt to access the Rotating Lever

Latch, push against the 8' lever arm at the end of the cover

and turn Rotating Lever Latch to release lever arm of cover.

Repeat for opposite end.

Flip the vinyl cover skirting over on top of the cover at the

corners to prevent these points from catching and being

damaged when starting to roll cover open (Figure 11).

Standing at one end of the swim spa, start rolling cover until

it is out of reach (Figure 12). Then, move to the long side

of the swim spa. Grasp the rolled portion of the cover by

the grey insulating bag (Figure 13) and continue rolling cover

open until it is past the entry step area in the swim spa

(approximately 3' to 5').

From this point; it is easiest to get into the swim spa, standing

in the center, to continue rolling cover open. Push upward on

the bottom grey insulating bag of the cover (Figure 14) and roll

until the cover is fully removed from over the body of water

(Figure 15).

FIGURE 14

BE SURE NO PERSON, CHILD OR ANIMAL IS POSITIONED

AT THE END OF THE SWIM SPA WHERE THE COVER WILL

BE LOCATED WHEN OPEN AND SWIM SPA IS IN USE. THE

ROLLED COVER IS HEAVY. SERIOUS OR FATAL INJURY

COULD OCCUR IF COVER ROLLS OR FALLS OFF THE END

OF THE SWIM SPA.

Indice

Altri manuali Master Spas Vasca idromassaggio

Master Spas

Master Spas MP Swim Spa Manuale utente

Master Spas

Master Spas LEGEND LSX700 Manuale utente

Master Spas

Master Spas INT GS BAR HARBOR LE Manuale utente

Master Spas

Master Spas LEGACY Manuale utente

Master Spas

Master Spas Michael Phelps Signature Swim Spas Manuale utente

Master Spas

Master Spas LS 850 Manuale utente

Master Spas

Master Spas TWILIGHT Series Manuale utente

Master Spas

Master Spas Trainer 12 Manuale utente

Master Spas

Master Spas INT MP FORCE Manuale utente

Master Spas

Master Spas MICHAEL PHELPS CHILLY GOA COLD TUB VALARIS Manuale utente

Master Spas

Master Spas LEGEND LSX700 Manuale utente

Master Spas

Master Spas 2008 Manuale utente

Master Spas

Master Spas H2X Challenger Manuale utente

Master Spas

Master Spas H2X Challenger Manuale utente

Master Spas

Master Spas Trainer 12 Manuale utente

Master Spas

Master Spas H2X Challenger Manuale utente

Master Spas

Master Spas INT EVO COMPACT Manuale utente

Master Spas

Master Spas legacy whirlpool Manuale utente

Master Spas

Master Spas LEGEND XTREME SERIES Manuale utente

Master Spas

Master Spas LEGEND LSX700 Manuale utente

Master Spas

Master Spas Down east Manuale utente

Master Spas

Master Spas TS 240 Manuale utente

Master Spas

Master Spas 2014 H2x Manuale utente

Master Spas

Master Spas jet Away Manuale utente

Manuali Vasca idromassaggio popolari di altre marche

Bestway

Bestway Lay-Z-Spa 54189 Manuale utente

Jacuzzi

Jacuzzi ARGA ARG101C0110 Manuale elenco delle parti

Morphy Richards

Morphy Richards Essentials PC4006 Manuale utente

Softub

Softub PRESTIGE Manuale utente

JNJ SPAS

JNJ SPAS SPA-318 Manuale di installazione

KIRAMI

KIRAMI Comfort Family Manuale utente

QCA Spa

QCA Spa VS501 PAK (VL260 TOPSIDE) Manuale utente

HoMedics

HoMedics FB-655HJ-GB Manuale utente

Everyday Hot Tubs

Everyday Hot Tubs 530 Manuale utente

anko

anko SS-601A Manuale utente

Jacuzzi

Jacuzzi Duetta 6042 Manuale utente

Pooli

Pooli OS030979B Manuale utente

Jacuzzi

Jacuzzi alimia Manuale utente

ab Solares Smart Spa Manuale utente

CalderaSpas

CalderaSpas CalderaSpas Utopia Series Manuale utente

Outsunny

Outsunny 848-047V70 Manuale utente

Aquatic

Aquatic INFINITY 1 Manuale utente

Asteria

Asteria 5630 Manuale utente

Master Spas axis Manuale operativo

Manuali Vasca idromassaggio popolari di altre marche