NOTE: The Models MP-MBA-45T-1 and MP-MBA-60T-1 has been tested
and certified by the Water Quality Association according to NSF/ANSI 44
for the specific performance claims as verified and substantiated by test
data as follows:
MP-MBA-45T-1 Rated Efficiency: 4590 Grains per pound of salt
5.25 lbs salt: 24.1 Kg Capacity
13.5 lbs salt: 47.3 Kg Capacity
22.5 lbs salt: 54.6 Kg Capacity
Rated Service Flow: 10.0 GPM @ 14.5 psi pressure drop
Resin: 1.5 CU FT cation exchange resin
MP-MBA-60T-1 Rated Efficiency: 4250 grains per pound of salt
5.0 lbs salt: 21.3 Kg Capacity
12.0 lbs salt: 39.8 Kg Capacity
20.0 lbs salt: 46.0 Kg Capacity
Rated Service Flow: 15.0 GPM @ 14 psi pressure drop
Resin: 2.0 CU FT cation exchange resin
Water Softener Positioning:
1. Place water softener in desired position, far enough from walls
and other obstructions to allow for servicing the unit.
2. Place the water softener within reasonable access to a grounded
115V/60 HZ circuit and a legal drain line connection.
Water Softener Tank Loading:
(MP-MBA-45T-1 and the MP-MBA-60T-1are preloaded at the factory)
1. Remove yellow caplug from top of tank.DO NOT CUT white
riser tube. Tube was prefitted at the factory.
2. Center the distributor and make sure it is resting on the bottom of
the tank. The top of the distributor pipe will extend above the top
of the tank (this was prefitted at the factory).
3. Cover the top opening of the distributor pipe before filling the
tank with media.
4. Pour the C-800 provided with the unit into the top of the tank.
See page one for your specific model number unit to determine
the amount of media to load into the mineral tank.
5. Remove the material used to cover the top opening of the
distributor pipe.
