Matrix MDI6011 Manuale di riferimento
Integrated Dishwasher
MDI6011
parts +1 year labour
year
guarantee
www.matrixappliances.co.uk
Manual for installation,
use and maintenance
2
Contents:
3 Important information
5 Important notes
6 Recommendations and steps before first use
7 Using your appliance
10 Buzzer sound control
11 Save power mode
12 Detergent
13 Salt
14 Softener adjustment
15 Rinse aid
17 Dishwasher baskets
18 Standard loading and test data
19 Programme listing
20 Care and maintenance
22 Failure codes and troubleshooting
23 Troubleshooting
24 Electrical information
26 Installation
29 Fitting the decor door
30 Warranty and service
3
Important
•Read the instructions prior to installation and use of the
appliance.
•Do not lean or climb on the open dishwasher door, to
prevent damage.
•Close the dishwasher door after use, to prevent accidents.
•Use only detergents, salt and rinse aid specifically
designed for dishwashers.
•Do not put solvents in the dishwasher detergent
compartment, to prevent risk of explosion.
•Only put dishwasher safe items into the dishwasher. If in
doubt, check with the manufacturer of the items.
•Take care when loading the dishwasher to observe the
recommendations for best loading practice, and also
to ensure that sharp objects such as knives are placed
blade down, to prevent accidents.
•Do not open the dishwasher door when a programme is
running. If it is necessary to do so, then open it only slightly
to allow the dishwasher to pause the programme and
prevent any water spilling out. Remember that the water
in the dishwasher can be very hot when the programme is
running.
•When the dishwasher is not in use, we recommend that
you turn off the water supply at the supply tap and
disconnect the mains supply.
•If you are leaving the dishwasher for an extended period
you should leave the door slightly open to prevent the
formation of unpleasant smells.
•The plastic housing on the water inlet pipe contains an
4
electrically operated valve. The wires that connect to this
valve are inside the inlet hose. Do not cut through the inlet
hose, and do not put the plastic housing in water.
•Children could get locked inside the appliance. Therefore
when disposing of an old appliance, cut off the plug and
set aside, and damage the door lock so that the door can
no longer be closed.
•This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note
that CDA reserve the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance.
This appliance is not designed to be used by people (including children)
with reduced physical, sensorial or mental capacity, or who lack
experience or knowledge about it, unless they have had supervision
or instructions on how to use the appliance by someone who is
responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
5
Appliance information
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault with your
appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
EU Declarations of Conformity
This product meets the requirements of all applicable EU directives with
the corresponding harmonised standards, which provide for CE marking.
Availability of this manual in an alternative format:
A soft copy of this manual is available for download from www.cda.eu.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT
IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a special local
authority waste collection centre or to a dealer providing appliance
recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin.
6
Recommendations
• To reduce energy and water consumption, remove all dirt residues
from the dishes prior to loading the dishwasher.
• Loading the dishwasher to the capacity indicated by the
manufacturer will save energy and water.
• Place hollow items (bowls, glasses and pans) face down in the basket.
• Do not put dishes, cutlery or other items with tobacco ash, wax,
lubricating grease or paint residues in the dishwasher.
• It is not recommended to pre-rinse the tableware, as this leads to an
increase in water and energy consumption.
• Washing tableware in a household dishwasher usually uses less
energy and water than washing up by hand.
Before First Use
•Set the water softener level as required for the water hardness in the
area.
•Add 1kg of salt into the salt compartment and then fill with water to the
top of the salt compartment.
•Remove all the packaging materials from the interior of the dishwasher.
•Fill the rinse aid compartment.
•Run a hot programme without any dishes in the dishwasher.
7
Control Panel
“On/Off” button (1)
To switch the dishwasher on or off, press the “On/Off” button (1).
When you switch on the dishwasher, two dashes will appear on the
programme display .
“Programme Selection” button (2)
To select a programme, press the “Programme Selection” button (3). The
dishwasher will store in its memory the last programme used.
Half load button (3) and indicator light (7)
The dishwasher is equipped with a half-load function that allows for small
numbers of dishes to be washed, spread between both baskets. This
reduces the amount of water and electricity used. To use this function,
press the half-load button (3). The indicator light (7) will illuminate and
shows that this function is selected.
“Delay timer” button (4)
The dishwasher is equipped with a delay timer which will delay the start of
a programme for 3, 6 or 9 hours. Pressing this button (4) once will delay the
start time for 3 hours, and continuing to press will increase the delay time.
End
End
50 C 65 C 50’ 65 C prewash
Fig. 1 5
6
7
8
8
Press the Delay button to change or cancel the delayed start. If you switch
off the machine while delay timer is active, the delayed time is cancelled.
The delay time indicator (5) will illuminate for the corresponding time set.
“Salt” and “Rinse Aid” warning lights and “End of Programme” light (6)
When either the dishwasher salt or rinse aid begins to run out, a warning
light will illuminate to advise that it needs refilling.
When the programme is complete, the dishwasher will emit five beeps
and the “End of Programme” light will illuminate.
“Programme Indicator” lights (8)
These lights will illuminate to confirm which programme has been
selected. If there is a fault on the dishwasher, the fault code will show on
these lights (page 20).
Starting a programme
• Press the “On/Off” button (the “End of Programme” light will be switched
on).
• Press the “Programme Selection” button until the required programme is
shown on the indicator lights.
• Once a programme is selected, the “End of Programme” light will
switch off.
• When you close the dishwasher door, the programme will start
automatically.
• If possible, avoid opening the door once a programme has started.
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme, simply press
the “Programme Selection” button.
9
At the end of a programme
At the end of a programme, the dishwasher will beep five times, and the
“End of Programme” indicator light will switch on.
Changing a programme
It is possible to change the programme, if necessary, once the
programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the “Programme Selection” button until the required programme is
shown on the display.
• Close the door. The dishwasher will begin the new programme from
the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel a programme once is has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold in the “Programme Selection” button until the “End of
Programme” indicator flashes.
• Close the door. The dishwasher will run a drain cycle which will take
approximately 30 seconds. Once this is complete, the dishwasher will
beep five times and the “End of Programme” light will switch on.
Switching the dishwasher off
• Once the dishwasher beeps five times and the “End of Programme”
light switches on, the dishwasher can be switched off by pressing the
“On/Off” button.
• If leaving the appliance off for a long time, turn off the water tap and
remove the plug from the power socket.
Please note: The dishwasher should automatically continue on the
programme it has started if the door is opened or in the event of a
power cut.
10
Buzzer sound control
To change the buzzer sound level, follow the below steps:
1. Open the door and press Programme (2) and Half Load (3) buttons
simultaneously for 3 seconds.
2. When sound setting is recognized, buzzer gives a long sound and
machine will display last set level, from “S0” to “S3”.
3. To decrease sound level press Programme button (2). To increase
sound level, press Half load button (3).
4. When the sound level is changed, corresponding LEDs illuminate as
shown in the table below.
Sound level LEDs
Half Load 3h 6h 9h
S0 X
S1 X X
S2 X X X
S3 X X X X
5. To save the selected sound level, turn off the machine.’’S0’’ level
means all sounds are off. The factory setting is “S3”
Indice
Altri manuali Matrix Lavastoviglie
