Pro Basic/Vario Serie
MechaPlus
www.cnc-modellbau.net
3
Mould the threads in the parts corners in the same way as you did at the frame parts. Please
do not screw in the mounting foots in these parts yet. That will be done later.
Then, lay out all frame parts, the four corners and the strut(s) on an even surface where the
entire machine will be assembled. Now, start with one frame part side and a corner, and slide
the profile connectors of the frame part side gently into the groove of the corner part until
both parts lay even on the surface. Continue with the frame part rear face and mount it on the
corner part of the already assembled frame. Afterwards, mount the second corner part on the
other side of the rear face. Then, take the remaining frame part side and mount it on the
previously assembled corner part.
You must slide the strut(s) work area into the lower groove of the frame between the frame
part sides. Only then should you assemble the remaining two frame parts corner and the front
face.
Once all parts have been mounted together, the headless screws of the profile connectors need
to be screwed tightly so that all frame parts are firmly attached to each other.
If there are any gaps between frame parts after all headless screws have been
tightened, then the Torx M8 screws of the profile connectors need to be screwed
in further.
The frame is now assembled and should look like
the one shown in Figure 2. Because the frame is
laying on the work area, the mounting feet should
be screwed into the frame parts corner. After that,
the frame can be set on its feet and the plastic caps
can be plugged into the corner parts. That
completes the assembly of the frame.
Figure 2: Assembled frame of a CNC-machine
of the Pro Line 06-05
