6
Lamp Replacement
Caution!
1. Disconnect po er before you begging.
2. Allo 15min for the unit and lamp to cool.
3. Do not touch lamps glass envelope ith your fingers. If this happens clean ith alco-
hol / to remove oils.
Remove the scre s X, Y, and Z for re-lamping
Adjust lamp position by turning scre s A,B and C
Disconnect the fixture from AC po er before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min. Before opening covers
And removing lamp from fixture.
WARNING!
Maximum room temperature t=40ºC
Minimum distance from flammable material d=0.7m.
Exterior surface temperature T=80ºC.
Not for domestic use.
X
Z
Y
A
C
To insert the lamp MSR 575/2, NSK575 or MSD 575. Us a Phillips
scre driver to unscre the bolts marked XY and Z. Carefully pull out
the cover ith the lamp socket and remove the old lamp from the
socket. Make a note that there is a large and small pole insert the ne
lamp into corresponding socket.
Do not install a higher attage lamp this ill void your arranty. Please
note the light bulb manufactures arnings. Do not touch the bulb ith
bare hands. Close lamp cover hile making sure that the cables are
not pinched or touching the lamp. Tighten the XYZ scre s.
Before striking the lamp reset the lamp timer by going to the LAti sec-
tion of your display screen. In order to reset the lamp counter to 0 you
have to hold the up and do n button and press the enter button.
Due to the difference bet een lamps. Fine adjustment may improve light performance. You ill need to strike the lamp and set
the light so the optical path is clear. You ill need to turn the scre s A, and C one after another a slight turn clock ise and
counter clock ise until you set the hot spot of the light in the center of the image. If no hot spot can be seen then set the lamp till
the light is evenly distributed.
Lamp Placement
Lamp Adjustment
Rigging the fixture
Caution!
1. The installations must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24inches a ay from flammable materials (decoration material)
4. Use high quality installation equipment to hang unit.
When rigging a unit it is very important that you follo common safety procedures. Rigging requires extensive experience includ-
ing but not limited to calculating orking loads, material being used and periodic safety inspections. If you lack these qualifica-
tions, do not attempt the installation yourself, instead use a professional structural rigger.
When rigging the unit al ays be secured ith a secondary safety attachment. The installation location of the projector has got to
be built in the ay that it can hold 10 times the eight for 1 hour ith out any harming. Installation should be checked at least
one time a year by a skilled person.
