2
1. Choose a mounting location suitable for your application such as a wall, flat surface, or a pedestal with a 76mm x 76mm mounting pattern.
Locate the keypad at least 1.8m away from any moving part of the gate and where the user cannot reach over, under, around or through the
gate to operate the controls. The mounting location needs to be in line of sight of the moving gate.
2. Unlock and remove the faceplate from the mounting plate.
3. Mount the mounting plate to the desired surface and secure with screws or bolts.
4. Reattach the faceplate to the mounting plate and lock with the key.
5. The garage door / gate opener must be programmed to accept the new keypad code. See basic programming.
Replacing Battery:
1. Unlock and remove the faceplate from the mounting plate.
2. Remove the battery cover using a screw driver. Change the battery (9V Lithium battery) and re-install inner cover.
3. Re-attach the faceplate to the mounting plate and lock with the key.
INSTALLATION
BASIC PROGRAMMING
The E850G Keypad must be put into programming mode prior to any of the programming steps below unless otherwise indicated. The 6-digit Master
Code is used to prevent unauthorized access to the system. A Master Code is required (factory default code: 888888) to setup the E850M Keypad.
It is highly recommended to change and record your unique Master Code.
The keypad backlight will remain on if the product is in programming mode. While in programming mode, if an invalid Master Code is entered, an
error tone will sound. The keypad will remain in programming mode. After 60 seconds of inactivity, the keypad will exit the programming mode.
Set Master Code
Programming Step Keystroke Combination Indicator
1. Enter program mode *(Master Code) # Long tone
2. Update Master Code 09 # (New 6-digit Code) # (New 6-digit Code) # Long tone
3. Exit Program Mode * * # Keypad backlight will turn off
Program your regular 4-digit PIN
Programming Step Keystroke Combination Indicator
1. Enter program mode *(Master Code) # Long tone
2. Set new pin 01 # (New 4-digit PIN) # Repeat (new 4-digit PIN)
#
Long tone
3. Exit Program Mode * * # Keypad backlight will turn off
NOTE: An error tone will sound if the maximum number of PINs is exceeded or if user tries to program a PIN already programmed in
the memory.
PROGRAM TO OPENER
NOTE: The Master Code and a PIN need to be set before the opener can be connected to keypad. See Basic Programming.
1. Press the Learn Button on the opener.
2. Within 30 seconds - Enter a valid 4-digit PIN then press #. A long tone will sound.
The keypad is now programmed to the opener.
OPERATION
To operate the opener using the wireless keypad
1. Enter the 4 digit user code. The keypad backlight will come on with the first digit
2. Press #. A long tone will be heard.
Three tones will be heard if the code is not valid.
