7
OPERATION MANUAL
SAFETY CHECKS BEFORE OPERATING
qEnsure xed guards are in place to prevent hands or other parts of the body from entering
the trapping space.
qGuards or safety devices must never be removed or adjusted, except by an authorized
person for maintenance purposes.
qWorking parts should be well lubricated and free of rust and dirt.
qThe area around the machine must be adequately lit and kept free of materials, which
might cause slips or trips.
qBe aware of other personnel in the immediate vicinity and ensure the area is clear before
using equipment.
qFamiliarize yourself with and check all machine operations and controls.
qEnsure cutting table is clear of scrap and tools.
qFaulty equipment must not be used. Immediately report suspect machinery
SAFETY CHECKS WHEN OPERATING
qDo not attempt to cut material beyond the capacity of the machine.
qNever attempt to cut rod, strap or wire with this machine.
qUse correct lifting procedures when handling large sheets of material.
qTake extreme care during the initial feeding of the workpiece into the machine.
qThe workpiece should always be held suciently far back from the edge being fed into the
guillotine.
qEnsure ngers and limbs are clear before actuating the guillotine.
qHold material rmly to prevent inaccurate cutting due to creep.
qWhen cutting ensure feet are positioned to avoid contact with the foot operated lever.
SAFETY CHECKS AFTER OPERATION
qRemove all o cuts and place them in either the storage rack or waste bin.
qLeave the work area in a safe, clean and tidy state.
POTENTIAL HAZARDS
qCuts from the sharp edges and burrs on the sheets before and after cutting
qParts of the body being caught in crush and pinch points.
qInjuries caused when handling metal sheets
