Meteor BOLT MINI Manuale utente
INSTALLATION GUIDE
GLARE SHIELD VISOR
meteor-lighting.com
Page 1
• Before wiring to power supply and during servicing or relamping, turn off
power at fuse or circuit breaker.
• All servicing or relamping must be performed by qualified service personnel.
• Product must be grounded to avoid potential electric shock or other potential
hazard.
• Product must be installed at locations and heights, in a manner consistent
with its intended use, and in compliance with Electrical Code and local codes.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Page 2
INSTALLATION GUIDE
BOLT MINI Glare Shield Visor
Meteor Lighting reserves the right to make changes to this product for design and development improvements at any time without prior notice, and such modification
shall be effective immediately. ©Meteor Illumination Technologies, Inc.
meteor-lighting.com 1300 John Reed Court, Unit B, City of Industry, California 91745 E: tech@meteor-lighting.com T: 213-255-2060
Put the shield on the fixture.
1. Place the tubes in these locations for support.
2. Align the shield to the top of the fixture so the screw holes
line up.
Finish
Tighten the screws in areas where arrows are pointed.
3
21
2
1
Indice
Altri manuali Meteor Attrezzatura di illuminazione
Meteor
Meteor WHIZ 2.0 Manuale utente
Meteor
Meteor ELIPSCAN Manuale utente
Meteor
Meteor BOLT NOVA Manuale utente
Meteor
Meteor ProMover P64 MOVING YOKE FIXTURE Guida rapida
Meteor
Meteor TETRISS 2.0 Manuale utente
Meteor
Meteor BOLT MINI Manuale utente
Meteor
Meteor VELA 4 Manuale utente
Meteor
Meteor DEXT MINI Series Manuale utente
Meteor
Meteor CONDUIT MOUNT Manuale utente
Meteor
Meteor VELA 5 Manuale utente
