mFi mFi-DS Manuale utente
Door Sensor
Model: mFi-DS
Introduction
Thank you for purchasing the
Ubiquiti mFi™
mFi-DS is designed for use with
connected, you can use the mFi
Controller software to monitor
your sensors using your Web
Switch
Magnet
Screw
Terminals
Switch Features Screw Terminals
and attaches to the frame of the
Magnet Attaches to the door or
Installation Requirements
Installation Tips
For optimal performance,
use one of these end-to-end
configurations:
configuration:
Max. 20 mm
you install the mFi-DS as high up
as possible, either at the top or on
Ubiquiti Networks Support
Email: suppor[email protected]om
Phone: 408-942-1153
Wiki Page: wiki.ubnt.com
Support Forum: forum.ubnt.com
Downloads: downloads.ubnt.com
Door Sensor
Model: mFi-DS
Wiring Instructions
Perform these steps to connect the
wire from the Switch to the mPort:
Insert each pre-stripped wire at
one end of the
into each Screw Terminal
Tighten each Terminal Screw
, repeat steps 1-2 to
connect the wire to the Iand O
Terminals of the
Connect the to
the
Mounting Instructions
!
Mount the Magnet onto the
Align the Switch with the
Magnet so their edges line up
when the door or window is
Mount the Switch onto the
Refer to the User Guide on the
your mFi mPort for instructions on
configuring the mFi-DS in the mFi
www.ubnt.com/mfi
Altri manuali per mFi-DS
1
Indice
Altri manuali mFi Accessori
