8©2010 Microban 44035-01 20100616
Figure 10.
Replace The UVC Bulb
The UVC light should be replaced once yearly� Follow
these instructions to remove and replace the UVC bulb�
1� Unplug the unit from the wall outlet and remove the
back grill by pressing down on the top tab�
2� Remove the 2 screws holding the Photcatalytic Screen
in place and remove the screen� Figure 9�
3� Remove the 3 screws holding the UVC Guard in place
and remove it from the unit� Figure 10� & 11�
4� Grasp the bulb with your thumbs and forefingers at
the plastic top and bottom and gently roll the bulb to
the left� Figure 12�
Figure 11.
4� Check the Pre-Filter side facing the grill for particle
coverage�
5� If the Pre-Filter needs to be cleaned, It may be
submerged in warm soapy water to clean� Gently lift
and submerge the filter several times to clean�
6� When complete, rinse the filter with warm water and
allow to dry completely�
Note: Wet parts placed into the unit can cause damage
to the filters and or the motor of the Air Purifier�
Check or Clean Your Filter
1� Turn the Air Purifier off and disconnect from the wall�
2� Remove the rear grill on the back of the unit by
pressing the tab at the top of the unit, under the
handle and pull the rear grill outward� Figure 7�
3� Remove the Permanent HEPA Filter from the unit�
4� Check the Filter for particle build-up�
5� To clean, use a vacuum cleaner with an upholstery
brush attachment, gently run the upholstery brush
over the cleanable filter until all particles are removed
from the filter� An arrow indicating which side to clean
is present on the top of the filter� Figure 8�
Note: Filter discoloration is normal and will not be
removed by vacuuming� Do not attempt to wash the filter
as damage to the filter or Air Purifier may occur�
Figure 8.
Figure 9.
Screws
Screws
