Microbrain Intelligent Technology ITS-AXX Manuale utente
Barrier Gate Control Radar
(Collision Avoidance Type)
User’s Manual
Changsha MicroBrain Intelligent
Technology Co., Ltd.
ITS-AXX
2
Copyright Notice
Thank you for purchasing
ITS-AXX Barrier Gate Control
Radar with collision avoidance
for smart access radar products.
To ensure the best performance
of the radar product, you are
kindly invited to read this user’s
manual carefully, then you are
strongly suggested to install and
debug it strictly following the
instructions provided in this
manual.
The copyright of the hardware
and software design about this
3
product belongs to Changsha
MicroBrain Intelligent
Technology Co., Ltd., and is
protected by law. No unit or
individual shall infringe these
lawful rights.
In order to further improve the
quality and performance, the
specifications and designs of this
product may be changed
without notifications. All rights
reserve belongs to Changsha
MicroBrain Intelligent
Technology Co., Ltd.
4
Content
1.Introduction.....................................5
2.Technical Specifications...............8
3.Features ............................................9
4.Installation Instructions ............. 13
5.Interface Definition..................... 18
6.Configuration Instructions ....... 22
7.Remarks ......................................... 26
5
1.Introduction
ITS-AXX barrier gate control
radar is developed for the
entrance and exit management
of parking lots or underground
garages. It can precisely control
the rising and falling of the gate
rod by cooperating with the
main control board of the gate
control system, effectively avoid
the "accidental injury" of the
gate rod to the passing vehicles
or pedestrians in the radar field
of view,and realize intelligent
anti smashing.
ITS-AXX radar adopts the
highly integrated RF chip SOC
6
scheme, which has the
characteristics of small size, low
cost, all-weather work, high
detection sensitivity, high
precision, easy to debug and
installation, very good stability
and reliability.
The working frequency of the
radar is among 77GHz-81GHz,
with Linear Frequency
Modulation and Continous
Waveform, which makes the
available bandwidth
up to 4GHz.The range
resolution is up to 4cm, and
ranging accuracy is better than
2cm; Millimeter wave antenna
adopts multiple transmitting and
7
multiple receiving configuration,
with high angular resolution and
angle measuring accuracy; signal
processing and control unit
adopts DSP + ARM dual core
architecture. Through the joint
optimization design of software
and hardware, this product can
accurately identify and
distinguish the pedestrian,
vehicle and other targets passing
through the brake lever area,
and avoid the phenomena of
"smashing the vehicle",
"smashing the person" and "not
dropping the lever".
8
2.Technical Specifications
Terms
Parameter
Value
Working
Condition
Input
Voltage(Volts)
10~16
Temperature
Range(℃)
-40~85
Power(W)
< 2.5
Water
Rissistance
Level
IP67
Connection
Interface
RS485
Size(mm)
107.5*73.2*
18
9
The appearance of ITS-AXX
Detection
Zone
Along Road
Width
Default ±
0.5m
(configurabl
e within ±
1m)
Cross Road
Range
Default 3 m
(configurabl
e within 6
m)
Upgrade
and
Debug
Online
debugging
Serial Port
Debug
Online update
Serial Port
Upgrade
3.Features
10
radar is shown in Figure 1. The
main features are:
LED indicators
There are two LED indicators on
the surface of the front surface
of ITS-AXX radar.
The red LED is the power state
lamp which will stay on when the
power supply is turned on;
The green LED is the operating
status lamp which will be
automatically trigger on when
objects detected in the access
area and it goes off when there
is no objects.
Detection Zone configuration
Indice
