microSHIFT ADVENT 1 Series Manuale utente
ADVENT 1x Rear Derailleur Installation
RD001-005
www.microSHIFT.com
© 2019 microSHIFT |AD-II Engineering Inc.
Before installing the products, please read and understand the installation
procedures. Improper installation can lead to premature product failures or
even injuries. If you have any questions on how to install, please contact us
or consult with a professional bicycle mechanic.
REMINDER
1
1. Torque wrench
2. 4mm & 5mm Hex bits
3. Screwdriver
4. Chain breaker
5. Cable cutter
6. Tape measurer
2
Attach rear derailleur to the bike. Make sure the B-tension washer is
above the derailleur dropout and engages correctly with the B-tension
adjustment screw.
3
Part I
8-10 Nm
Tighten the rear derailleur fixing bolt to 8-10 Nm with a 5mm hex bit torque
wrench. Check to make sure that the derailleur can rotate freely.
4
Part II
Using a screwdriver, adjust the high-limit screw until the guide pulley
aligns with the outer edge of the smallest cog.
5
Every frame manufacturer has different cable routing guidelines, so make
sure you consult those before cutting the housing. ADVENT works best
when there is not too much of a curve in the housing, and not too little slack
either. Make sure the end of the housing is sitting against the rear derailleur
as well.
6
Part I
7
Part II
Before installing the cable, use the index trigger lever to shift to the
highest gear.
8
Part I
Route the cable through the shifter, housing, and rear derailleur.
9
Part II
Altri manuali microSHIFT Accessori per biciclette
