Microview A Series Guida utente

aSERIES DVR04/DVR08 DIGITAL VIDEO RECORDER

Quick Operations Guide

UD.7L0202B1365B01

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.

This manual is applicable to MicroView DVR04 and DVR08 models.

DVR Pre-Installation

The DVR is highly advanced surveillance equipment that should be installed with care. Please take into

consideration the following precautionary steps before installation of the DVR.

1. Keep all liquids away from the DVR.

2. Install the DVR in a well-ventilated and dust-free area.

3. Ensure environmental conditions meet factory specifications.

4. Install a manufacturer recommended HDD.

DVR Installation

During the installation of the DVR:

1. Use brackets for rack mounting.

2. Ensure there is ample room for audio and video cables.

3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.

4. Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.

5. Ensure the DVR is grounded.

6. Environmental temperature should be within the range of -10 ºC ~ 55 ºC, 14ºF ~ 131ºF.

7. Environmental humidity should be within the range of 10% ~ 90%.

Hard Disk Installation

Before you start:

Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A

surveillance-class storage HDD is recommended for this installation.

Tools Required: Screwdriver.

To install a HDD on your DVR:

1. Remove the cover from the DVR by unfastening the screws on the back and side.

2. Install the HDD in the HDD rack using the provided screws. Fasten the screws on the bottom to fix the HDD.

3. Connect the HDD to the motherboard of the DVR with the included data cable, and connect the power cable

to the HDD.

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

4. Re-install the cover of the DVR and fasten screws.

Front Panel

Table 1 Description of Indicators

No.

Icon

Description

1 Indicator turns red when DVR is powered up.

2 Indicator lights in red when data is being read from or written to HDD.

3 Indicator blinks blue when network connection is functioning properly.

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

Rear Panel

The rear panel of DVR08 is shown below:

The DVR04 and DVR08 provides no HDMI interface.

Table 2 Description of Rear Panel

No. Item Description

1 VIDEO IN

BNC connector for analog video input.

2 VIDEO OUT BNC connector for video output.

HDMI

HDMI video output.

The DVR04 and DVR08 provides no HDMI interface.

4 VGA DB15 connector for VGA output. Display local video output and menu.

5 AUDIO IN RCA connector for audio input.

6 AUDIO OUT RCA connector for audio output.

7 LAN Interface RJ45 10M / 100M Ethernet interface.

8 USB Interface Connects USB mouse or USB flash memory devices.

9 12V 12VDC power supply.

10 GND Ground (needs to be connected when DVR starts up)

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

Specifications

The DVR04 and DVR08 provides no HDMI interface.

Model

DVR08

Video/Audio

input

Video compression H.264

Video input

4-ch

8-ch

Video input interface

BNC (1.0 Vp-p, 75 Ω), PAL /NTSC self-adaptive

Audio compression

G.711u

Audio input

1-ch, RCA (2.0 Vp-p, 1 kΩ)

Two-way audio input 1-ch, RCA (2.0 Vp-p, 1 kΩ) (using the audio input)

Video/Audio

output

HDMI/VGA output

1-ch, resolution:

1080P: 1920×1080/60Hz, SXGA: 1280×1024/60Hz,

720P: 1280×720/60Hz, XGA: 1024×768/60Hz

CVBS output 1-ch, BNC (1.0 Vp-p, 75 Ω),

resolution: PAL: 704 × 576, NTSC: 704 × 480

Encoding resolution

WD1/4CIF/2CIF/CIF/QCIF

Frame rate 25 fps (P) / 30 fps (N)

Video bitrate

32 Kbps ~ 3072 Kbps, or user defined (Max. 3072 Kbps)

Audio output 1-ch, RCA (Linear, 1 kΩ)

Audio bitrate

64 Kbps

Dual-stream Support;

Sub-stream: CIF/QCIF @ 25 fps (P) / 30 fps (N)

Stream type Video, Video & Audio

Synchronous

playback

4-ch 8-ch

Hard disk SATA 1 SATA interface

Capacity

Up to 4TB capacity

External

interface

Network interface

1, RJ45 10M / 100M Ethernet interface

USB interface

2, USB 2.0

General

Power supply

12 VDC

Consumption

(without hard disk)

≤ 6 W ≤ 8 W

Working temperature

-10 ºC ~+55 ºC

Working humidity

10% ~ 90%

Dimensions

(W × D × H)

200 × 200 × 45 mm 200 × 200 × 45 mm

Weight

(without hard disk) ≤ 0.8 kg ≤ 1 kg

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

HDD Storage Calculation Chart

The following chart shows an estimation of storage space used based on recording at one channel for an hour at

a fixed bit rate.

Bit Rate

Storage Used

96Kbps

42 MB

128Kbps

56 MB

160Kbps

70 MB

192Kbps

84 MB

224Kbps

98 MB

256Kbps

112 MB

320Kbps

140 MB

384Kbps

168 MB

448Kbps

196 MB

512Kbps

225 MB

640Kbps

281 MB

768Kbps

337 MB

896Kbps

393 MB

1024Kbps

450 MB

1280Kbps

562 MB

1536Kbps

675 MB

1792Kbps

787 MB

2048Kbps

900 MB

3072Kbps

1350 MB

Please note that supplied values for storage space used is just for reference. Storage space used is

estimated by formulas and may have some deviation from actual value.

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

Menu Operation

Menu Structure

The menu structure of the DVR04 and DVR08 is shown as below:

The DVR04 and DVR08 provides no PTZ feature.

Startup and Shutdown

Proper startup and shutdown procedures are crucial to expanding the life of the DVR.

Before you start:

Check that the voltage of the extra power supply is the same with the device’s requirement, and the ground

connection is working properly.

Starting up the device:

Steps:

Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an Uninterruptible

Power Supply (UPS) be used in conjunction with the device. The Power indicator LED should turn red indicating

that the unit begins to start up.

Shutting down the device:

Steps:

1. Enter the Shutdown menu.

Menu > Shutdown

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

2. Click the Shutdown button to enter the following dialog box:

3. Click the Yes button. The following message box pops up:

4. Disconnect the power supply of the device.

Using the Setup Wizard

The Setup Wizard can walk you through some important settings of the device. By default, the Setup Wizard starts

once the device has loaded.

Operating the Setup Wizard:

You can set the system language after the device is started. Click Apply to save the language settings.

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

1. Check the checkbox to enable Setup Wizard when device starts. Click Next to continue the setup wizard.

You can also click Cancel to exit the Setup Wizard, or use the Setup Wizard next time by leaving the “Start

wizard when device starts?” checkbox checked and exit.

2. Click Next button on the Wizard window to enter the Login window.

1) Enter the admin password. By default, the password is 12345.

2) To change the admin password, check the New Admin Password checkbox. Enter the new password

and confirm the password in the given fields.

3. Click the Next button to enter the Date and Time settings window.

Set the time zone, date format, system date and system time.

aSERIES DVR04 / DVR08 Digital Video Recorder · Quick Operations Guide

4. Click Next button which takes you back to the Network Setup Wizard window.

Set the network parameters, including the NIC type, IPv4 address, IPv4 subnet mask, default gateway, etc.

You can enable the DHCP to automatically obtain an IP address and other network settings from that

server.

5. Click Next button to enter the HDD Management window.

To initialize the HDD, click the Init button. Initialization removes all the data saved in the HDD.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Microview Registratore digitale

Microview

Microview MVINVR-08POE4MP-E Manuale utente

Manuali Registratore digitale popolari di altre marche

FLIR

FLIR M3100E Series Manuale utente

VTRACKPRO

VTRACKPRO FPRO300 Manuale utente

Swann

Swann NVR-7085 models Manuale utente

XtendLan

XtendLan DVR-1670C Manuale utente

urmet domus

urmet domus 1093/004AHD Manuale utente

Holux

Holux M1 Manuale utente

CMOS DOTCOM

CMOS DOTCOM ANX-1670 Manuale utente

Whistler

Whistler D16VRS Manuale utente

Defender Security

Defender Security 82-20235 Manuale utente

MISUMI

MISUMI MP-WF100M Manuale utente

Speco

Speco D8HU Manuale utente

UST

UST DDR-E04AA Istruzioni per l’uso

Consolidated

Consolidated Digital Video Recorder Manuale utente

Mace

Mace DVR0404RW Guida rapida

RCA

RCA RTD315W Manuale utente

FSM

FSM Colibri Grande PRO Manuale utente

Hauppauge

Hauppauge HD PVR 2 Manuale utente

Identivision

Identivision ICR-PH161i PIONEER Manuale utente