
2 3
TITAN SERIES INSTALLATION GUIDANCE midstreamlighting.com +44 (0) 207 584 8310
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Contents 1. General notes
Section PAGE
1 General notes 3
2 Safety instructions 3
3 Contents 4
4 Electrical connection 6
5 Bracket mounting & Floodlight installation 8
6 Electricalspecications 10
7 Centreofgravity 10
8 Weight and windage 10
9 Dimensions 11
This user manual contains important information on safe
operation of the Luminaire.
Read and follow all safety notes and all instructions. Save
this manual for future reference. Make sure that it is available
to all persons using this device.
All wiring should be done by a licensed electrician
in accordance with state codes, local codes, and
National Electric Code (NEC) standards or International
Electrotechnical Commission (IEC) standards.
The Luminaire is suitable for wet locations.
DO
9Store the Luminaire with care, avoiding placing the lenses
to the ground which may scratch or damage them.
9To avoid damaging the Luminaire, keep it in the original
packaging when storing.
9When handling the Luminaire, wear industrial safety gloves
and safety boots.
DO NOT
8Apply mains voltage through the control system cable.
This will damage the luminaire.
8Unnecessarily remove the Luminaire from the box
8Leave the LED Luminaire switched on when rested on the
ground with optics facing down.
8Place the Luminaire with the lens on the pavement, dirt
and metal surfaces.
8Clean the lenses with any industrial detergent, but with
water-soaked cloth if needed
Two persons required to
complete the installation
The Luminaire should
be positioned so that
prolonged staring into the
luminaire at a distance
closer than 4 m (13 ft) is
not expected
Hard hats, safety
shoes, Hi-Vis vest and
safety gloves must
always be worn
Disconnect the electrical
supply power before
commencing the
installation: failure to
do so could result in
serious injury
The luminaire is not to be
placed face down on any
surface other than the
provided foam pad
The light source of this
appliance must only
be replaced by the
manufacturer, its
after-sales service or
qualiedpersonnel
2. Safety instructions
Use the device only as described in this user manual. Any other
use or use under other operating conditions is considered to be
improper and may result in personal injury or property damage
as well as voiding the warranty..
No liability will be assumed for damages resulting from improper
installation. This device may be used only by persons with
sucientphysical,sensorial,andintellectualabilitiesandhaving
corresponding knowledge and experience.