Miele KM6357 Manuale utente
Installation Instructions
KM 6357, KM 6386 en - CA
Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.
The appliance must be installed by
a qualified professional and
connected to the electric power
supply by a qualified electrician.
The cabinet and the hood above the
cooktop must be installed before the
cooktop to avoid damaging it.
~The countertop must be
heat-resistant (up to 100°C), so that it
does not become deformed or the
veneer detached.
The wall strips must be heat-resistant
as well.
The cooktop must not be installed
above refrigerators/freezers,
dishwashers or washer/dryers.
~This cooktop must not be installed
above a stove or oven unless they have
a built-in cooling fan.
~Ensure that the connection cable
cannot be touched nor be subject to
any mechanical strain after the cooktop
has been installed.
All measurements are given in mm.
Safety instructions for installation
62
Safety clearance above the cooktop
For an exhaust hood above the
cooktop, always use the clearance
specified by the hood manufacturer.
If there are no specifications from the
hood manufacturer or if flammable
materials (e.g. a utensil rail) are
installed above the cooktop, the
clearance must be at least 760 mm.
If there is more than one appliance
installed below the exhaust hood,
each with a different safety
clearance, the largest clearance
must be used.
Safety clearances
63
Safety clearances to the sides and
back of the cooktop
There may be a cabinet or a room wall
of any height at the rear and on one
side (right or left) of the cooktop (see
illustrations).
a50 mm minimum distance between
the back of the countertop cut-out
and the rear edge of the countertop.
b50 mm minimum distance between
the right of the countertop cut-out
and the nearest piece of furniture
(e.g. a tall cupboard) or a wall.
c50 mm minimum distance between
the left of the countertop cut-out
and the nearest piece of furniture
(e.g. a tall cupboard) or a wall.
Not permitted!
Highly recommended!
Not recommended!
Not recommended!
Safety clearances
64
Minimum clearance underneath the
cooktop
To ensure proper ventilation of the
cooktop, a minimum clearance is
required between the appliance and an
oven, protective base, or drawer.
The minimum clearance from the
bottom of the cooktop to
– the top of the oven must be 15 mm.
– the top of the protective base must
be 15 mm.
– bottom of the drawer must be 75
mm.
Protective base
Installation of a protective base under
the cooktop is allowed but not required.
A gap of 10 mm at the back is required
for the power supply cable.
For better cooling of the cooktop, we
recommend a gap of 20 mm at the
front.
Safety clearances
65
Safety clearance to a wall covering
A safety clearance must be maintained between the countertop cut-out and any
wall covering to protect it from heat damage.
If the covering is made of a combustible material (e.g. wood), a safety clearance
eof 50 mm must be maintained between the cut-out and the covering.
If the covering is made of a non-combustible material (e.g. metal, natural stone,
ceramic tiles), a minimum safety clearance eof 50 mm less the thickness of the
covering must be maintained between the cut-out and the covering.
Example: 15 mm wall covering
50 mm - 15 mm = 35 mm minimum clearance
Flush-fitted cooktops Cooktops with frame or bevelled edges
aMasonry
bWall covering
Dimension X = thickness of wall covering
cCountertop
dCut-out in the countertop
dMinimum safety clearance
for combustible materials is 50 mm
for non-combustible materials is 50 mm less dimension X
Safety clearances
66
Seal between cooktop and
countertop
The cooktop must not be sealed
with joint sealant. Cooktop and
countertop could get damaged if the
cooktop needs to be removed. Do
not use a joint sealant between
cooktop and countertop.
The seal under the edge of the upper
part of the cooktop provides an
adequate seal against the countertop.
Tiled countertop
The grouting aand the hatched area
below the cooktop frame must be
smooth and flat, so that the frame will
be level and the seal under the edge of
the upper part of the cooktop can
provide a seal against the countertop.
Instructions for installation
67
KM 6357
aFront
bCasing depth
cConnection for Miele|home
dMains connection box
The mains connection cable (1440 mm long) is supplied separately.
Building-in dimensions
68
KM 6386
aFront
bCasing depth
cConnection for Miele|home
dMains connection box
The mains connection cable (1440 mm long) is supplied separately.
Building-in dimensions
69
,CAUTION: Before installation or
servicing, disconnect the power
supply by either removing the fuses,
shutting off the power main or
manually "tripping" the circuit
breakers.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
responsible.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the data plate correspond with the
household electrical supply. This
data must correspond to prevent
appliance damage. Consult an
electrician if in doubt.
Only operate the cooktop after it has
been installed into the countertop.
Installer:
Please leave these instructions with
the consumer.
Power supply
^Make sure your electrical supply
matches the data plate.
Connection
The cooktop is ready for connection to
a grounded power supply.
KM 6357
208/240 V, 60 Hz, 40 A fuse rating
KM 6386:
208/240 V, 60 Hz, 50 A fuse rating
Connect as following:
Black wire: connect to L1 (hot)
Red wire: connect to L2 (hot)
Green wire: connect to GND (ground)
A dedicated line and junction box
should be used to connect the
KM 6357 to a 40 A circuit and the
KM 6386 to a 50 A circuit.
For further information, see the wiring
diagram provided with the appliance.
,WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Connecting the electrical supply
cable
The electric power supply cable
must be connected to the cooktop
by a qualified electrician.
Electrical connection
70
Altri manuali per KM6357
4
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Miele Piano cottura
Miele
Miele SmartLine CS 7612 FL Manuale utente
Miele
Miele GAS COMBISET CS 1011 Manuale utente
Miele
Miele KM360G Manuale utente
Miele
Miele KM 406 Istruzioni utente
Miele
Miele KM 3464 Manuale utente
Miele
Miele KM 5670 Manuale utente
Miele
Miele KM 6360 Manuale utente
Miele
Miele KM 404 Manuale utente
Miele
Miele KM 6320 Manuale utente
Miele
Miele ProLine CS 1212-1 Manuale utente
Miele
Miele KM 342 Manuale utente
Miele
Miele GAS COMBISET CS 1012 Manuale utente
Miele
Miele SmartLine Manuale utente
Miele
Miele KM 7404 FX Manuale utente
Miele
Miele KM 391 Manuale utente
Miele
Miele CS1122E Manuale utente
Miele
Miele KM6357 Manuale utente
Miele
Miele KM 404 Manuale utente
Miele
Miele KM 404 Manuale utente
Miele
Miele KM-5600 Manuale utente
