2 Important safety warnings
Carefully read and observe before putting into operation!
The present unit operates with acid, flammable and –
depending on the type of vaporizer liquid –toxic substances.
Therefore, a predetermined operating sequence and strict
observance of the safety and protection measures described
below are prerequisite.
The present operating instructions cannot take each and every
specific regulation into consideration which might apply in
various countries. The operator of the unit must ensure that all
relevant local regulations concerning the prevention of
accidents and the use of hazardous substances are known and
observed.
MIG-O-MAT soldering and welding units are intended for
soldering, welding and melting of metals. Operation is allowed
by industrial and commercial businesses only.
The unit must be operated by specialized, trained staff only.
The operating instructions must be strictly observed. The unit
must not be operated by unauthorized persons or by children.
For reasons of safety, the unit must be connected to a
shockproof socket only. The technical data indicated on the
nameplate must correspond with the available local connection
conditions, particularly with regard to mains voltage and current
consumption values.
For maintenance and service works, in case of liquid inside the
unit and malfunctions, and when you have finished working with
the unit pull the main plug. In case of a malfunctioning please
contact your supplier or the manufacturer.
The unit must be opened by authorized and specialized staff
only!
Electrolyte solution can cause severe chemical burns!
Always wear base-resistant gloves and goggles when you work
with electrolyte solution! Do not eat or drink while filling
electrolyte solution into the unit!
Wash your hands after filling the reactor!
Avoid contact with eyes and skin! In case of contact with the
eyes rinse the open eye(s) under running water for several
minutes and seek medical advice. In case of contact with the
skin wash immediately with soap and rinse thoroughly.
If you have overfilled the unit, do not remove any excess
electrolyte by sucking it through a hose by mouth. There is a
risk of severe chemical burns! If you have overfilled the unit by
mistake, use a suitable base-resistant suction device which is
not operated by mouth.