Page 4
Introduction
08
01
06
03
02
07
04
Click USB adapter board provides necessary interface for
connecting Click™add-on boards to your PC through high speed USB
connection. There is no need to use a microcontroller. It features
FT2232H dual high speed USB to multipurpose IC, Analog-to-
Digital converter, EEPROM memory and a single mikroBUS™host
socket. FT2232H provides necessary communication lines dened
by the mikroBUS™standard. mikroBUS™host connector consists of
two 1x8 female headers with SPI (MOSI, MISO, SCK, CS), I2C(SDA,
SCL), UART (Tx, Rx), RST, PWM, Analog and Interrupt lines as
well as 3.3V, 5V and GND power lines. Click USB adapter board
can be powered through USB cable only. On-board power circuitry
generates 3.3V and 5V. Two jumpers are provided on the board.
J1 jumper is used to select whether UART or I2C will be used. J2
selects whether AN pin on mikroBUS™socket will be just another
GPIO pin, or connected to MCP3204 AD converter circuit, thus
serving for analog readings.
05
09 01 TX/RX indication LED
02 USB MINI-B connector
03 Power indication LED
08 MCP3204 ADC converter
05 FT2232H IC
07 VIN/BC0 jumper (J2)
04 I2C/UART jumper (J1)
06 mikroBUS™socket
09 EEPROM memory
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
