Milford Instruments 7-574 Manuale utente
MILFORD INSTR
MILFORD INSTRMILFORD INSTR
MILFORD INSTRUMENTS Limited
UMENTS LimitedUMENTS Limited
UMENTS Limited
Rev 1.1 23/08/2012
Cased DMX 9 Channel LED Driver Board.
Part # 7-574.
Overview:
The DMX- 9 Channel LED driver board allows 9 PWM LED outputs to be controlled directly
from a DMX512 network.
The board provides 9 output channels of PWM running at 666 Hz.
The base address may be set between 1 and 504.
LED PWM:
The DMX value on the base address channel controls the PWM drive on output 1 a value of
0 will switch the load fully OFF and a value of 255 will switch the load fully ON, 128 will
generate a 50% duty PWM signal running at 1kHz. The resolution of the PWM stream is 8-
bit.
The value on the base address controls output 1, Base address + 1 controls output 2 etc.
The PWM signal is suspended when a valid DMX signal is not being received.
The Cased DMX 9 Channel PWM driver board is available in the following versions.
9-15 Vdc version: Part No 7-574 / 24 Vdc version: Part No 7-575
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United KingdomReg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Fax
FaxFax
Fax 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com
Page 2
Connections:
DMX: Dual 5 Pin XLR connections with termination resistor
XLR Pin1 = Cable Screen, 2 =XLR Pin2 = Data -, 3 =XLR Pin3 = Data + .
Power: Polarised Screw Terminal connections 0V & V+ (9-15Vdc) Standard Board, power
requirements are 9-15V DC at 0.5 Amps + LED’s load current: Maximum 9.5 amps if using
LED connections wired as A (18.5 amps if wired as B)
Outputs:
The 9 output channels are each rated at 2 Amps Maximum @ 9-24 VDC if wired as Figure
Band are arranged as open collector outputs.
RGB LED’s should be common anode format wired to a “+” terminal and the cathodes to the
relevant “-“ input on the board.
N.B. All LEDs must include suitable current limiting resistors.
Indicators:
Digital Display: Displays base address
DMX Failure: Flashes ---/ERR if no valid DMX signal is being received.
Read DMX: Press to read current base address DMX value.
Power: The Digital Display will be lit.
Ch 1 Monitor LED: Visual indication of the PWM level on Channel 1.
Base Address Selection:
The base address can be set between 1 and 504 using the Up/Down buttons
Press and hold the DMX Read button to display the current DMX value on the base address.
Channel One DMX fault setting:
Press and hold the DMX read button whilst applying power, release the button, then adjust
the PWM level on channel one using the Up/Down buttons (0-255) then press Read DMX
again to save changes and exit.
Mechanical:
Cased dimensions W170mm x D140mm x H50mm
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United KingdomReg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Fax
FaxFax
Fax 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com
Page 3
Connection Diagram.
PSU
DMX In/Out
Aux 0V connections
Current
Limiting
resistors
At up to 9 amps total LED current connect Leds as “A”
Above 9 amps total LED current connect Leds as “B”
A
B
1-574E Cased Version
XLR Pins
P1 Screen Continuation
P2 Data – (minus)
P3 Data + (plus)
DMX Connections
Ch 1 PWM Monitor
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
9
8
7
6
5
4
3
2
1
0V V+
+
Read DMX
-
Indice
Altri manuali Milford Instruments Hardware per computer
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
