Page 3 of 9 rev 100321 Millennia Media NSEQ
Introduction
Congratulations on your purchase of the Millennia
Media NSEQ Equalizer. It uses a minimalist design
which has only one active stage in the audio path
(Dove Topology). This results in full timbral control
with total signal integrity.
The NSEQ-2 features Twin Topology®.You have
your choice of a Tube OR Solid State signal path.
The NSEQ-4 uses the world's first (and only) all-
discrete, true differential Class-A input
buffer/amplifier along with an all discrete J-FET solid
state signal path
We will refer to both the NSEQ-2 and NSEQ-4
as NSEQ unless there is an operational
difference.
The NSEQs are the result of meticulous listening
tests on numerous circuit, topology, and packaging
designs. Your NSEQ is a finely tuned instrument
intended for critical professional applications —we
feel it is the world's most sonically neutral analog
EQ. With the emergence of 24+ bit digital audio,
recording engineers are faced with a new
requirement for undistorted dynamic range. The
NSEQ meets this challenge exceptionally well.
Before connecting power to the NSEQ, assure that
the rear panel voltage selection fuse block switch is
set correctly. In the USA, the NSEQ is shipped with
the voltage selection block set to 100-120 VAC. At
this voltage setting, a pair of 1 amp 5 x 20 mm slow
blow fuses have been factory installed. If you change
the voltage selection block to 200-240 VAC usage,
be sure to change both fuses to 500 milliamp (0.4
amp) slow blow types.
Safety Precautions
For your safety and the safety of others, be sure to
read and understand all safety and operational
instructions before attempting to use the NSEQ.
WARNING: The NSEQ's internal circuitry carries
lethal voltages. Carefully observe all warnings,
precautions, and instructions on the NSEQ and as
described in the instructions supplied with the unit.
Water, Moisture, and Spillage –Do not attempt
to use the NSEQ in, near, or around water or in
unusually moist environments, such as near a sink
or swimming pool. Prevent liquids or any other
materials or objects from spilling or falling into the
NSEQ unit.
Heat & Ventilation –Be sure to allow adequate
ventilation on both sides of the NSEQ and avoid
blocking the vents.
Power Sources & Power Cord Protection –The
NSEQ Power Supply should be connected to a power
source only of the type described in the operating
instructions or as marked on the Power Supply.
Route the power cord so that it is not likely to be
walked on or pinched by having objects placed on it.
Pay particular attention to plugs, receptacles, and
the point where the AC power cord exits the
NSEQ.
Grounding –For your safety, it is extremely
important that the grounding pin of the 3-wire power
cable (included with 110 Volt units) be inserted into
a grounding type 3-pin power outlet. If you are
unable to insert the plug into an existing outlet,
contact an electrician to install a properly grounded
3-pin power outlet, preferably that with OFI / GFI
protection, if available.
Damage Requiring Service –This unit should be
repaired or serviced by qualified personnel
whenever:
•The AC power cord has been damaged, or
•Objects have fallen or liquid has spilled into
any NSEQ unit, or
•The unit does not function properly or
exhibits a marked change in performance,
or
•The unit has been abused, dropped, or
damaged, or
•The unit has been exposed to rain or
moisture.
Servicing –Lethal voltages are found inside the
NSEQ chassis. The user should not attempt to repair
or service this unit. All servicing and/or repairs
should be referred to Millennia.
If, after reading all instructions, precautions, and
warnings, you have remaining questions, please
contact Millennia directly before attempting to use
your NSEQ.
The NSEQ enclosure measures approximately 17”
wide x 3.5” high x 12.5” deep and is designed for
mounting into a standard 1U, 19” equipment rack. If
the NSEQ is mounted in a road case or other rack
which is prone to strong vibration or shock, it is
highly recommended that the rear of the NSEQ be
supported or otherwise reinforced to withstand such
conditions.
NSEQ is designed on a common ground topology. For
high quality operation, and for your own safety and
the safety of others, do not defeat the power cord
earth grounding pin.
Any changes or modifications not expressly approved
by MILLENNIA MEDIA, FPC (Millennia) could void
your authority to operate this equipment under the
EC, ICAN, or FCC rules.
Copyright –You acknowledge that no title to the
intellectual property in the NSEQ is transferred to
you.
