- 3 -
Note:
1. When “display change mode” set in “auto” switch state, the LCD display screen
will switch to next page for each 10 seconds; when “background light control” set
in “auto” state, the LCD screen background light will be auto turn off without any
operate after three minutes. Once the fault appear or press any button, the
background light turns on. When “Background light” control setting as “constant
light”, the LCD background light will keep lighting.
2. Without Coolant temp. Oil pressure, or Fuel level sensor connection,、the
controller display “―――”，which does not affect controller normal work.
(3).Operation keys
Content Function
Press the button, controller in “start” state, the green LED keep
bright .This is start by manual, the generator will keep running.
(Auto)
Press the button, controller in “Auto” state, the yellow LED keep
bright. ①When the “Remote start” switch is turned off and mains
resume, the generator set will be stopped after cool down delay.
②When “Remote start” switch is turned on or mains failure, the
generator set will be delay started. ③If timing start generator is
valid, generator is be timing started. After the end of the timed
start, will delay shutdown.
Press the button, the above red LED keep bright, the controller is
in “stop/reset” state, it will unload, decelerate and idle stop, the
fuel will be cut off after idle delay. When During decelerate and
idle the “reset” indicator keep flash, keep light when generator
stop. If quickly press the button twice, generator will be cut off fuel
and stop immediately, without decelerate, idle process.
Press the button, yellow indicator keep bright. Controller in “TEST”
state. Start the generator by hand directly, when generator runs
in normal, the controller make generator onload automatically
and keeps onload running.(whether “remote start” switch turn
on/off
(4).State indicator light
Content Function
Indicate the generator set failure, protected stop, Display the fault
content.
Indicate the generator set warning information, Display alarm
detail
