Minolta ProShot MN67Z Manuale utente
1
Declaration of Conformity
Responsible Party: Elite Brands Inc.
Address: 40 Wall St, Flr 61, New York, NY 10005 USA
Company Website: www.elitebrands.com ;
www.minoltadigital.com
For Customers in the U.S.A.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
BEFORE
YOU
START
2
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
This product complies with the FCC portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this
manual. Additional RF exposure reduction can be achieved if the product can be kept
as far as possible from the user body or set the device to lower output power if such
function is available.
3
About this Manual
Thank you for purchasing this MINOLTA MN67Z Digital Camera. Please read this manual
carefully and keep it in a safe place for future reference.
Elite Brands Inc. reserves all rights of this document. No part of this published
manual may be reproduced, transmitted, transcribed, stored in a retrieval system
or translated into any language or computer language, in any form, by any means,
without the prior written permission of Elite Brands Inc.
All trademarks mentioned in this manual are used for identification purposes only
and are properties of their respective owners and holders.
This manual provides you with instructions on how to use your new MINOLTA MN67Z
Digital Camera. Every effort has been made to ensure that the contents of this
manual are accurate; however Elite Brands Inc. reserves the right to make changes
without notice.
Throughout this manual, the following symbols are used to help you locate
information quickly and easily:
Indicates useful information.
The following symbols may be used throughout this manual to facilitate your
understanding of how to operate the camera:
[Item properties]:The optional properties in the camera interface are indicated by the
[ ] symbol.
4
SAFETY
NOTES
Safety Notes for this Camera
Do not drop the camera or allow it to hit solid objects.
Do not attempt to disassemble or repair the camera.
Do not use or store the camera in dusty places or on a beach to help prevent dust or
sand from entering the camera, causing possible damage.
Do not use or store the camera in a hot environment or in direct sunlight.
Do not use or store the camera near powerful magnetic fields, such as a magnet or
transformer.
Avoid touching the lens of the camera.
Do not expose the camera to direct sunlight for a long period of time.
To prevent the camera from being damaged by moisture, do not use or store the
camera in very humid environments, such as in rain or near bodies of water.
If water accidentally comes in contact with the camera, turn the camera off
immediately, remove the battery and the memory card and dry it completely within
24 hours.
When you take the camera from a cold environment to a warmer environment,
condensation may occur. Please wait for a reasonable period of time before you turn
the camera on.
Before you remove the battery and memory card, the camera should be turned off.
5
When you clean the body of the camera, do not use abrasive, alcohol-based or
organic cleansers or solvents.
Use a professional lens cleaning cloth and appropriate cleaner to wipe and clean the
lens.
Download your photos and remove the memory card when you are going to store the
camera for long periods of time.
If this camera is not in use for a long period of time, please keep it in a dry and clean
storage location.
Our company will not pay compensation for any failure of playback including: pictures
or videos damaged or unrecoverable by improper operation.
Safety Notes for Battery
Please use a battery that is the same type as the one included.
Please use the attached charger to charge the battery.
If battery fluid leaks inside the camera, contact our customer service department
immediately. If battery fluid leaks onto your skin, rinse your skin immediately with
clean water and seek immediate medical attention.
Disposal of used batteries should be carried out in accordance with your local
(national or regional) regulations.
6
To prevent the battery from being damaged, do not drop the battery or allow it to hit
solid objects or to be scratched by foreign objects.
Do not let the battery come in contact with metal objects (including coins) to avoid
short circuiting, discharging, excessive heat or possible leakage.
Do not attempt to disassemble the battery.
Do not expose the battery to water. Always keep the battery contacts dry.
Do not heat the battery or throw it into a fire to avoid a possible explosion.
Do not store the battery in a hot environment or in direct sunlight.
If the battery overheats during charging or use, stop charging or use immediately.
Turn off the product, remove the battery carefully, and wait until it cools down.
When the camera is stored for a long period of time, remove the battery and keep it
in a safe, dry place that is not accessible to infants and children.
In colder environments, the performance of the battery could be noticeably reduced.
When you install the battery, align the battery markings according to the positive and
negative markings inside the camera battery compartment. Never force the battery
into the battery compartment.
7
Safety Notes for SD Memory Card
We highly suggest buying only well-known, name brand memory cards to ensure peak
performance and reliability.
Format the memory card using the camera before you use it or insert a new one.
Do not drop the memory card or allow it to hit solid objects to avoid damaging it.
Do not attempt to disassemble or repair the memory card.
Do not expose the memory card to water. Always keep it dry.
Do not remove the memory card when the camera is turned on. Otherwise, the
memory card and photo/video files could be permanently damaged.
Do not directly edit the data on the memory card. Copy the data to your computer
before you edit files.
When the camera is stored for long periods of time, be sure to download your photos
and remove the memory card. Store the memory card in a dry environment.
Do not modify the name of the files or folders of the memory card using your
computer. Modifying the file names may cause the files to not be recognized on the
camera or a possible permanent error may occur.
A photo taken with the camera will be stored in the folder that is automatically
generated on the memory card. Do not store photos that are not taken using this
camera in these folders as the pictures cannot be recognized during playback.
When you insert the memory card, make sure the notch of the card matches the
markings on the top of the camera card slot.
8
Other Safety Notes
Do not disconnect the power or turn the camera off during the update process. Doing
so may cause incorrect data to be written and the camera may not power on later.
Do not hang the neck strap of the camera around the neck of a child.
When using your camera on an airplane, observe the relevant rules specified by the
airline and FAA regulations.
Due to the limitations of manufacturing technology, the LCD may have a few dead
or bright pixels. These pixels do no effect the quality or performance of the camera,
photos or video.
Do not expose the camera’s LCD to water. In a humid environment, only wipe it with a
soft, dry, cleaning cloth.
If the LCD is damaged and the liquid crystal comes into contact with your skin, wipe
your skin with a dry cloth immediately and rinse it with clean water. If liquid crystal
comes into contact with your eyes, wash them with clean water at least for 15 minutes
and seek immediate medical attention. If you accidentally swallow liquid crystal, rinse
your mouth immediately and seek medical attention.
Trademark Information
The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade dress
and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing
Administrator, Inc.
9
BEFORE YOU START ............... 1
SAFETY NOTES ........................ 4
CONTENTS .............................. 9
GETTING READY ................... 13
Accessories Included .......................13
Installing Lens Cap and
Neck Strap.........................................14
Part Names .......................................15
Installing Battery and SD
Memory Card ....................................18
Charging the Battery .......................20
Vari-Angle LCD..................................21
Turning Camera On and Off ...........22
Set your Language, Date/Time.......23
Set your Language, Date/Time
after the First Power-On ...........23
Resetting your Language .........24
Resetting Date/Time..................25
MODE OVERVIEW................. 26
LCD Display .......................................26
Overview of the Screen Icons in
Shooting Mode...........................26
Overview of the Screen Icons in
Movie Mode................................28
Overview of the Screen Icons in
Playback Mode...........................29
How to Take Pictures .......................30
Using the Mode Dial ........................31
Face Beautifier ...................34
Wireless Mode ....................35
Scene Mode .....................41
Custom Settings ( )..............47
BASIC OPERATION ............... 49
CONTENTS
Altri manuali per ProShot MN67Z
1
Indice
Altri manuali Minolta Macchina fotografica digitale
Minolta
Minolta DYNAX 303 SI Manuale utente
Minolta
Minolta RIVA ZOOM 90c Manuale utente
Minolta
Minolta AF 101R Manuale utente
Minolta
Minolta DIMAGE E323 - SOFTWARE Manuale utente
Minolta
Minolta SR-T 101 Manuale utente
Minolta
Minolta Vectis 300 Manuale utente
Minolta
Minolta ProShot MN53Z Manuale utente
Minolta
Minolta K-QM-3501E - PART 5 Manuale utente
Minolta
Minolta DiMAGE image Viewer Utility Manuale utente
Minolta
Minolta DYNAX 7 Manuale utente
Minolta
Minolta DYNAX 3 Manuale utente
Minolta
Minolta Dimage S 304 Manuale utente
Minolta
Minolta RD-175 Manuale utente
Minolta
Minolta A2 Istruzioni per il montaggio
Minolta
Minolta DIMAGE A1 - SOFTWARE Manuale utente
Minolta
Minolta DiMAGE E223 Manuale utente
Minolta
Minolta MN5Z Manuale utente
Minolta
Minolta DYNAX 404SI MAXXUM STSI Manuale utente
Minolta
Minolta DIMAGE 2300 - AUTRE Manuale utente
Minolta
Minolta Vectis 300 Manuale utente
