5
WARRANTY
For the warranty of the commercial electric sauna stoves to be valid, the stoves
must have undergone the first installation-related maintenance and regular
maintenance every six months.
In commercial electric sauna stoves:
- Kerkes stove stones need to be used
- only fresh water may be thrown on the stones
- the stove or its surroundings may not be washed with pressure washer
- the Misa ERM control centre must be used to control the stove
The seller/manufacturer is not liable for damages caused by improper installation at
the site or by failure to follow the installation instructions.
In such cases, the company/installer that performed the installation is liable for
damages. IN ANY WARRANTY REPAIR CASES, THE SELLER WILL ONLY
COMPENSATE FOR SPARE PARTS, NOT INSTALLATION WORKS.
SAUNA STOVE STONES
Note! The commercial sauna stove must be pre-heated before the loading of the
stones. This way, any protective grease will burn away from the stove and heating
elements, and unpleasant odours will not stick to the stones.
First, load the round stove stones into both stone troughs, up to the “dorsal fin” of
the stove. Next, place the “tetra” stones on top of the round ones. Only one layer of
“tetra” stones should be laid on top of the round stones, so that the “dorsal fin” is no
longer visible.
Kerkes stove stones need not be washed before first use. We recommend
removing Kerkes stones from the stove and reloading them twice a year. Kerkes
stones can be treated with acid once a year to avoid lime deposits on the stones.
Good air circulation in the stone compartment is essential for efficient heating of the
sauna air and for the service life of heating elements.
WARNING
Using an insufficiently loaded stone compartment creates a fire hazard. An
insufficiently loaded stone compartment is not the same as a loosely loaded stone
compartment. Failure to comply with the specified minimum distances or other
installation requirements can cause a fire hazard. The sauna stove may not be
covered. Never hang combustible objects, such as towels, above the sauna stove
or in its vicinity, even after using the sauna. These will cause a fire hazard if the
sauna stove is switched on without inspecting the sauna first. Covering, short-
circuiting or otherwise restricting the functionality of the thermostat and temperature
limiter is prohibited, as this would create a fire hazard. If these components do not
work normally, the cause of the malfunctions must be identified and fixed before
using the sauna stove.
MANUFACTURER:
MISA OY Tel. VAT
Punaportinkatu 15 +358 20 710 9390 FI01620383
FINLAND www.misa.fi Alv rek.
