MobileDemand xTablet A1180 Manuale utente
xTablet A1180
2
User Manual
xTablet A1180
Contents
Copyright and Trademark Notice 3
FCC Information 4
IC Statements 5
Safety Instructions 6
Introduction 8
Product Overview 9
Specications 14
Power Supply 15
Battery 16
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
xTablet A1180
3
Copyright and Trademarks Notice
All marks and names mentioned may be trademarks of their respective owners. No warranty as to accu-
racy or completeness is expressed or implied. We reserves the right to make changes to this document
without prior notice.
Revision History
►Version: 1.0
►Date: 10, 2019
xTablet A1180
4
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and radiates radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
►Reorient or relocate the receiving antenna.
►Increase the separation between the equipment and receiver.
►Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
NOTE
►The changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
►Shield interface cables and AC power cord, if any, must be used in order to comply with the emission limits.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
►This device may not cause harmful interference.
►This device must accept any interference received, including interference that may cause undesired operation.
FCC/IC RF Radiation Exposure and SAR Statements
The xTablet A1180 has been tested for body-worn Specic Absorption Rate (SAR) compliance. The FCC/IC has established de-
tailed SAR requirements and has established that these requirements. This model meets the applicable government require-
ments for exposure to radio frequency waves. The highest reported SAR level for usage near the body (0mm) is 1.20 W/kg,
and for the simultaneous transmission is 1.52W/kg.
xTablet A1180
5
IC Statements
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes: il ne doit pas produire de brouillage et
l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si ce brouil-
lage est susceptible de compromettre le fomctionnement du dispositif.
CE Conformity
This device is in compliance with the essential safety requirements and other relevant provisions
set out in the European Directive.
Battery Regulations
European Union: Batteries, battery packs, and accumulators should not be disposed of as unsorted house-
hold waste. Please use the public collection system to return, recycle, or treat them in compliance with the
local regulations.
Taiwan: For better environmental protection, waste batteries should be collected separately for recycling or
special disposal.
California, USA: The button cell battery may contain perchlorate material and requires special handling
when recycled or disposed of in California.
For further information please visit: http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
Safety Guideline for Using Lithium Battery
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recom-
mended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.
WEEE Statement
European Union: Under the European Union (“EU”) Directive on Waste Electrical and Electronic Equipment,
Directive 2002/96/EC, which takes eect on August 13, 2005, products of “electrical and electronic equip-
ment” cannot be discarded as municipal waste anymore and manufacturers of covered electronic equip-
ment will be obligated to take back such products at the end of their useful life.
xTablet A1180
6
Read the safety instructions carefully, all cautions and warnings on the equipment or user’s manual
should be noted.
Keep this equipment away from humidity and high temperature.
The openings on the enclosure are used for air convection to prevent the equipment from overheating.
Do not cover the openings.
• Do not leave the equipment in an unconditioned environment with a storage temperature
above 60ºC (140ºF) or below -20ºC (-4ºF), which may damage the equipment.
• This unit should be operated under maximum ambient temperature of
50ºC (120ºF) or under 60ºC (140ºF) for light loading applications.
Requirements of battery storage:
1. If the storage duration is within 3 months, remain temperature at -20º ~45ºC ;
If the storage duration is above 3 months but within 1 year, remain temperature at 23º± 2ºC.
2. The battery capacity should remain at 30 ± 5%.
3. The storage humidity should remain at 65 ± 25%RH.
4. The battery charging temperature should be 10º ~45ºC , the discharging temperature should be
-20º ~60ºC.
5. For the maximum battery discharging performance, remain storage temperature at 25ºC.
Make sure the power voltage is within safety range and has been adjusted properly to the value of
100~240V before connecting the equipment to the power outlet.
• Always unplug the AC power cord before installing any add-on card or module to the equipment.
• Always disconnect the AC power cord or uninstall the battery pack or switch o the wall socket if the
equipment would be left unused for a certain time to achieve zero energy consumption.
Place the power cord in a way that people are unlikely to step on it. Do not place anything on top of
the power cord.
Safety Instructions
xTablet A1180
7
Always keep strong magnetic or electrical objects away from the tablet.
Never pour liquid into the opening that could damage the equipment or cause electrical shock.
If any of the following situations arises, get the equipment checked by a service personnel:
• The power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• The equipment has been exposed to moisture.
• The equipment has not worked well or you can not get it work according to User’s Manual.
• The equipment was dropped and damaged.
• The equipment has obvious signs of breakage.
Green Product Features
• Reduced energy consumption during use and stand-by
• Limited use of substances harmful to the environment and health
• Easily dismantled and recycled
• Reduced use of natural resources by encouraging recycling
• Extended product lifetime through easy upgrades
• Reduced solid waste production through take-back policy
Environmental Policy
• The product has been designed to enable proper reuse of parts and recycling and should not be
thrown away at its end of life.
• Users should contact the local authorized point of collection for recycling and disposing of their
end-of-life products.
xTablet A1180
8
Introduction
Congratulations on the purchase of MobileDemand’s xTablet®A1180. Designed and tested to meet
our exacting standards ensures dependability and customer satisfaction.
Refer to this manual to guide you through the basic functions and features.
Unpacking
Unpack the shipping carton and check all items carefully. If any item is damaged or missing contact your local dealer
immediately. Please keep the box and packing materials in the event you need to ship the unit. The package should
contain the following items:
• XTablet A1180
• AC/DC adapter and AC power cord
• Tether
• Hand strap
• Brief case handle
• Stylus
xTablet A1180
9
Product Overview
1 2
3
4
1. Front Camera
2. Status LED
3. Internal Microphone
4. Touch Screen
xTablet A1180
10
1. Volume
2. Power • Connect with AC power before powering on for the rst time.
• Press and hold the power button for 4 seconds can shut down the Tablet.
3. Barcode Scanner (optional)
4. Headphone Jack
1 2
1. Dock Supports
2. Dock Connector
1 12
1. Kensington Lock
1
3 4
Indice
Altri manuali MobileDemand Tavoletta
MobileDemand
MobileDemand xTablet T1175 Manuale utente
MobileDemand
MobileDemand xTablet T8540 Manuale utente
MobileDemand
MobileDemand xTablet T1180 Manuale utente
MobileDemand
MobileDemand xTablet T1180 Manuale utente
MobileDemand
MobileDemand xTablet T1190 Manuale utente
MobileDemand
MobileDemand xTablet Flex 8 Manuale utente
MobileDemand
MobileDemand A1150 Manuale utente
MobileDemand
MobileDemand T1150 Manuale utente
MobileDemand
MobileDemand T8700 Manuale utente
MobileDemand
MobileDemand xTablet T1200 Manuale utente
MobileDemand
MobileDemand xTablet T1400 Manuale utente
MobileDemand
MobileDemand ND51 Manuale utente
MobileDemand
MobileDemand T1600 Manuale utente
MobileDemand
MobileDemand xTablet Flex 10A Manuale utente
MobileDemand
MobileDemand T8650 Manuale utente
MobileDemand
MobileDemand xTablet T1200 Manuale utente
MobileDemand
MobileDemand EM-I16H Manuale utente
MobileDemand
MobileDemand T1600 Manuale utente
MobileDemand
MobileDemand xTablet T1270 Manuale utente
MobileDemand
MobileDemand xTablet T1200 Manuale utente
