Mockett PCS87/M/USB Manuale utente

USER MANUAL

MODEL:

PCS87/M/USB

Flip-Up Power Grommet

Contents

Introduction 1

Getting Started 1

Overview 2

Typical Applications

Product Overview

Installation 5

Drilling a Hole in the Table

Mounting the PCS87/M/USB in a Table

Connecting the Cables and Wires

Operating Instructions

Technical Specifications

Getting Started

We recommend that you:

•Unpack the equipment carefully.

•Review the contents of this user manual.

Achieving the Best Performance

•Use only good quality connection cables to avoid interference, deterioration in signal

quality due to poor matching, and elevated noise levels (often associated with low

quality cables).

•Do not secure the cables in tight bundles or roll the slack into tight coils.

•Avoid interference from neighboring electrical appliances that may adversely influence

signal quality.

•Position your PCS87/M/USB away from moisture, excessive sunlight and dust.

This equipment is to be used only inside a building. It may only be connected to other

equipment that is installed inside a building.

Safety Instructions

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Use only the power cord that is supplied with the unit.

Warning:

Do not open the unit. High voltages can cause electrical shock! Servicing by

qualified personnel only.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

Overview

The PCS87/M/USB is an elegant furniture-mounted, flush round power grommet.

The unit features a pneumatic mechanism for pneumatic lifting and smooth closing of its

lid. It is easily installed into a table or podium top, and its interface enables you to

connect any equipment to systems installed in a room via the following connectors:

•Two US power sockets (5A when connecting a single power socket and a total of 6A

when connecting both sockets).

•Two 2A USB ports for charging devices.

•One HDMI connector (supporting HDMI with Deep Color, x.v.Color™, Lip Sync, HDMI

Uncompressed Audio Channels, Dolby TrueHD, DTS-HD, and CEC).

•One C14 power socket and one HDMI connector on the underside of the unit.

Product Overview

Feature

Function

Pop-up Lid

Covers the connecting surface, leaving the table surface neat and

tidy.

Outer Rim

Fits over a table surface.

Pneumatic Mechanism

Enables automatic lifting and smooth closing of the lid.

Connecting Surface

See Figure 2.

Rubber Protectors (x2)

Protect the table surface when mounting the unit.

Locking Butterfly Nuts (x2)

Tighten to lock the mounting butterfly screw.

Mounting Screws (x2)

For securing the PCS87/M/USB to the table.

Mounting Butterfly Nuts (x2)

Tighten to secure the unit to the table surface.

Feature

Function

Mounting Brackets (x2)

Place in the bracket slits after inserting the enclosure into the table,

for securing the unit to the table surface

Mounting Bracket Slits (two slits

on each side)

Insert the mounting brackets to the slits when installing the

PCS87/M/USB .

HDMI Cable

Connect to an HDMI acceptor.

Unit Features

Figure 2: PCS87/M/USB Connecting Surface

Feature

Function

5A/125V Power Connector (x2) Connect to a US power consuming device.

When a single power socket is connected,

consumption should not exceed 5A.

When both power sockets are connected, the total

consumption should not exceed 6A.

5V-2A USB CHARGING Port (x2) Use to charge up to two devices simultaneously.

Lid Latch For safely closing the lid.

HDMI Connector Connect to an HDMI source.

Installing the PCS87/M/USB

Drilling a Hole in the Table

To drill an opening in a table:

1. Using any standard cup bit drill with a diameter ranging from 111mm to 114mm (4.37”to

4.49”), drill a hole in the table in the desired location.

The thickness of the table should be 76mm (3”) or less.

2. Clean the table surface.

Take care not to damage the table. Mockett is not responsible for any damage caused to

the table.

Mounting the PCS87/M/USB in a Table

To mount the unit, follow these steps:

Step 1: Insert the PCS87/M/USB into the

hole cut into the table, making sure the

outer rim is firm against the surface of the

table.

Step 2: From underneath the table, slide the

mounting brackets into the appropriate slots.

Step 3: Tighten the butterfly mounting screws

securely upward against the table.

Step 4: Lock the mounting screws into position

with the locking butterfly screws.

Connecting the Cables and Wires

Following installation connect the cables to the underside of the unit:

•Connect the power cable to a power source.

•If applicable, connect the HDMI connector to an HDMI acceptor.

Make sure that when:

• A single power socket is connected, consumption should not exceed 5A.

• Both power sockets are connected, the total consumption should not exceed 6A.

Using the PCS87/M/USB

Once the PCS87/M/USB is installed, you can easily customize it to your own needs by

directly plugging in the required AV equipment.

Figure 3: Connecting PCS87/M/USB

Technical Specifications

Ports

1 HDMI

On an HDMI connector

2 USB Ports

5V, 2A on female USB-B connectors

for charging devices

2 US Power Sockets

For powering devices

Power

Consumption

125V AC, 50/60Hz, 6.3A

Fuse Rating

T 6.3A 250V

Environmental

Conditions Operating Temperature 0° to +40°C (32° to 104°F)

Storage Temperature -40° to +70°C (-40° to 158°F)

Humidity 10% to 90%, RHL non-condensing

Regulatory

Compliance Safety CE, UL

Environmental RoHs, WEEE

Enclosure Type Aluminum

Accessories Included Clamps

When a single power socket is connected,

consumption should not exceed 5A.

When both power sockets are connected, the total

consumption should not exceed 6A.

Indice

Altri manuali Mockett Accessori

Mockett

Mockett PCS100C-U Manuale utente

Manuali Accessori popolari di altre marche

Hillco

Hillco 2810 Manuale utente

Siemens

Siemens QSA2700D Manuale dell'operatore

Contours

Contours ZY024 Manuale utente

Saivod

Saivod VS621 Manuale utente

Virtuox

Virtuox VirtuCLEAN 2.0 Manuale utente

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuale utente

Z-Wave

Z-Wave HSD-200Z Manuale utente

turck

turck FMX-IM-2UPLI63FX Manuale utente

Decagon Devices

Decagon Devices 10HS Manuale utente

UPPAbaby

UPPAbaby Cup Holder Manuale utente

Elko

Elko SmartSensor Leakage Wireless Manuale utente

Grizzly

Grizzly H8371 Manuale utente

Panasonic

Panasonic HG-T Series Manuale utente

IFM Electronic

IFM Electronic Efector 250 Series Guida di riferimento

DigiDesign

DigiDesign 888/24 I/O Manuale utente

PROZIS

PROZIS QUAY Manuale utente

patagonia

patagonia PSI Vest Manuale utente

SFC Energy

SFC Energy EFOY GO! Manuale utente