Mockett PCS100B/UC Manuale utente
4X
1/4" RAD.
2-1/8"
CUTOUT
5-27/32"
(6" CUTOUT)
6-3/8"
TABLE OF CONTENTS
1-15/16"
(2-1/8" CUTOUT)
. . . . . . . . . . . . 2X Wire Guide
2-5/8"
. . . . . . . . . . 1X PCS100B/UC
SPECIFICATIONS
·6 ft. cord length.
·USB-A and USB-C are for charging use only.
·Table thickness is 3/4" MIN. to 1-1/2" MAX.
FRONT VIEW
. . . . . . . . . . . . . . . 2X 1/2"
No. 10 Pan Head
Wood Screw
. . . . . . . . . . . . . . . 1X Clamp
·For indoor use only.
·For use on a normally dry work surface.
·If any malfunction occurs, do not attempt to disassemble or
repair.
·Avoid placing the charger in a high temperature environment
or near fire.
!! WARNING
SIDE VIEW
Guide the cord through the cutout. Install the unit into the
cutout and make sure it is fully level on the work surface.
Make a cutout in the desired location on your work surface.
Allow enough clearance for unit operation. DO NOT place unit
where cable is strained or trapped. (Note: Cutout corners
must contain 1/4" radius.)
21
3/32"
3-5/32"
6"
CUTOUT
310.318.2491 • 800.523.1269 • www.mockett.com
DOUG MOCKETT & COMPANY, INC.
PCS100B/UC
2023.09.21
PROPRIETARY AND CONFIDENTIAL.
ALL DIMENSIONS HAVE A +/- 1/16" TOLERANCE UNLESS OTHERWISE SPECIFIED. WE DO NOT RECOMMEND DRILLING OR
CUTTING ANY HOLES BEFORE RECEIVING A PRODUCT OR A PRODUCT SAMPLE.
1
Align the (2) 1/2" No. 10 pan head wood screws with the
mounting holes on the wire guides to lock the cord in place
under the work surface. Plug the unit into nearby outlet and
unit is ready for use.
34
Lock the clamp by sliding to the edge of the mounting tab.
Secure the unit by tightening the (4) screws.
Place power cord into (2) wire guides.
65
Mounting
Tab Screws
Align the slot opening of the clamp to the mounting tab.
Make sure to align the cord notch of the clamp to the power
cord. (Note: Mounting tabs must point up when installing
vertically.)
Clamp
1/2" No. 10
Pan Head
Wood Screw
Wire
Guide
Cord
Notch
310.318.2491 • 800.523.1269 • www.mockett.com
DOUG MOCKETT & COMPANY, INC.
PCS100B/UC
2023.09.21
PROPRIETARY AND CONFIDENTIAL.
ALL DIMENSIONS HAVE A +/- 1/16" TOLERANCE UNLESS OTHERWISE SPECIFIED. WE DO NOT RECOMMEND DRILLING OR
CUTTING ANY HOLES BEFORE RECEIVING A PRODUCT OR A PRODUCT SAMPLE.
2
Altri manuali Mockett Ciabatta elettrica
