Introduction
PRODUCT KEY FEATURES:
•Four circuits of trailing edge dimming
•Operation in either Scene or Impulse mode
• Six editable scenes with selectable scene fade times
• Master raise and lower of overall brightness
•Multiple configuration options to ensure compatibility with a variety of light fittings.
• User selectable button colours
•Four configurable multi-function remote switch inputs
•Holiday mode to simulate occupancy
•Optional IR remote control
•Various fascia plate finishes available
BEFORE YOU START:
Once installed, SceneStyle will operate with default values without further setup.
By default, SceneStyle is configured to work with many different light fittings, which
may cause some light fittings not to dim as low as expected or at all.
With certain fittings, it is possible to achieve a lower minimum brightness than the
default value. To decrease the minimum circuit brightness, see entering the
configuration menus (p.10) and follow the instructions to enter the circuit
configuration menu.
If lights fail to turn on at minimum brightness, boost mode may be required. Refer
to the troubleshooting guide for further guidance.
It is normal for the fascia plate to become warm during operation.
SAFETY NOTICE:
•SceneStyle must be installed by a qualified electrician or other competent person.
Installation should be in accordance with the National Wiring Regulations or other
applicable regulations. Compliance with the EC EMC or Low Voltage Directives may be
invalidated if not used or installed to the published specification.
•Isolate (turn off) the mains power at the main consumer unit (fuse box) before installation
or any maintenance, including changing blown light fittings.
•Read the Installation instructions and safety notes in full prior to installation.
2
