Mopar K6860274 Manuale utente
K6860274 – SDARS ANTENNA
Click on the desired vehicle to take you directly to the vehicle specific
instructions.
RAM
300/CHARGER/
CHALLENGER
CALIBER
COMMANDER
COMPASS
DAKOTA
DURANGO/ASPEN
GRAND CHEROKEE
MINIVAN
PATRIOT
Aug 08, 2008 K6860274 Rev. 1
1
SDARS ANTENNA
COMMANDER
PROCEDURE STEPS:
1. Disconnect and Isolate the negative battery cable.
2. Using Trim Stick C-4755, or equivalent, release the retaining
clips that secure the header trim molding (1) in the liftgate
opening and remove.
3. Remove the push pins from the headliner at the rear of the
vehicle.
4. Using Trim Stick C-4755, or equivalent, disengage the
retaining tabs that secure the liftgate scuff plate to the liftgate
door sill and remove the scuff plate (1).
NOTE: Load oor shown, jack tray similar.
4/1/2008 K6860274 Rev. 1
2
5. Equipped with Load Floor - Remove the two nuts (1) that
secure the load floor to the floor panel.
6. Remove the load floor.
7. Equipped with Third Row Seats - Remove the four nuts
holding in the jack storage compartment.
8. Remove the jack storage compartment.
NOTE: Drivers side shown, passenger side similar.
9. Remove the passengers side rear door scuff plate.
10. Remove the passengers front door scuff plate.
4/1/2008 K6860274 Rev. 1
3
11. Remove the passenger side cowl trim panel (1).
NOTE: Passenger side shown, driver side similar.
12. Position the third row seat down.
13. Remove the screw cover for the third row seat release and
remove the lever (2), both sides.
14. Using a trim stick C-4755 or equivalent, disengagethe
retaining tabs that secure the D-pillar trim panel to the
retaining clips in the D-pillar and remove the trim panel, both
sides.
15. Remove the trim plug (1) from the upper c-pillar trim, both
sides.
4/1/2008 K6860274 Rev. 1
4
16. Using a magnetic screwdriver or equivalent, remove the upper
screw and pull the upper part of the trim panel (1) away from
the pillar and release the bottom tabs (2).
17. Position aside the c-pillar trim, both sides.
18. Pull the grab handle downward, remove the two screws that
secure the grab handle to the roof panel, and remove the grab
handles from the headliner.
19. If equipped, disconnect the reading lamp wire connector from
the grab handles, both sides.
20. Partially separate the door seals from the door opening, both
sides.
21. Remove the screws and the cargo net d-ring that secure the
quarter trim panel to the quarter panel.
22. Using a trim stick C-4755 or equivalent, disengage the
retaining tabs that secure the quarter trim panel to the quarter
panel.
23. Pull the quarter trim panel away from the quarter panel (3).
24. If equipped, disconnect the rear heater control connectors (1).
25. Remove the quarter trim panel.
26. Separate the glove box damper rod (1) from the clove box by
sliding the rod towards the rear of the vehicle to release it from
the bin.
27. Open the glove box and carefully use fingers to press down
glove box open stops at the top of the bin, downward to allow
the glove box to rotate toward the carpet.
28. Rotate the box down and release the door hinges (2) at the
bottom and remove the glove box.
4/1/2008 K6860274 Rev. 1
5
29. Using a trim stick C-4755 or equivalent, remove the shifter
bezel.
30. Remove the radio bezel screw.
31. Remove the radio mounting fasteners.
WARNING: Disable the airbag system before attempting
any steering wheel, steering column, or instrument panel
component diagnosis or service. Disconnect and isolate the
negative battery (ground) cable, then wait two minutes for
the airbag system capacitor to discharge before performing
further diagnosis or service. This is the only sure way
to disable the airbag system. Failure to take the proper
precautions could result in an accidental airbag deployment
and possible serious or fatal injury.
CAUTION: Pulling the antenna cable straight out of the radio
without pulling on the locking antenna connector could
damage the cable or radio.
32. Disconnect the electrical connector and remove radio.
33. Starting at the radio, route the harness from the rear of the
radio along the bottom of the glove box and secure to the
support brace (1).
34. Route the antenna down to the cowl trim area and secure to
the body harness.
4/1/2008 K6860274 Rev. 1
6
35. Route along the front passenger scuff plate and under the b-
pillar trim.
36. Route antenna harness along the rear passenger scuff plate
and up the c-pillar.
37. Route the antenna cable behind the rear HVAC housingand
secure to the body harness and up the d-pillar.
4/1/2008 K6860274 Rev. 1
7
38. Starting from the door side use a trim stick C-4755 or
equivalent, disengage the retaining tabs that secure the trim
ring (1) to the rear sunroof support bracket (2).
39. Remove the four mounting fasteners for the video monitor, if
equipped.
40. Disconnect electrical connectors (1) and remove monitor.
41. Remove the rear and center rear push pins from the rear of
the headliner (3).
CAUTION: Be careful not to crease the headliner.
4/1/2008 K6860274 Rev. 1
8
42. Cut out the template.
43. Center the template on the rear of the roof, aligning the
template with the roof edge.
44. Center punch the two holes marked on the template.
45. Remove the template.
CAUTION: Do not drill more than a 6 mm (1/4 in.), failure to do
so will result in damage to the vehicles headliner.
46. Drill a 3 mm (1/8 in.) pilot hole at each of the center punched
locations.
47. Drill the rear hole to 5 mm (13/64 in.).
48. Drill the front hole to 19 mm (3/4 in.).
49. Debur both of the holes.
50. Apply Mopar® Corrosion Inhibitor, p/n 82300508, to the bare
metal surface of the drilled holes.
51. Clean and prep the area for the antenna.
52. Install the satellite antenna. Tighten to 9 N·m (80 in. lbs.).
4/1/2008 K6860274 Rev. 1
9
53. Connect the antenna harness to the antenna.
54. Install the rear head liner push pins and the rear centerpush
pins.
55. Install the video monitor, if equipped.
4/1/2008 K6860274 Rev. 1
Indice
Lingue:
Altri manuali Mopar Antenna
Manuali Antenna popolari di altre marche
Alfa Network
Alfa Network APA-L01 Manuale utente
Naval
Naval PR-422CA Manuale utente
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Manuale utente
TERK Technologies
TERK Technologies TV44 Manuale utente
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Manuale utente
HP
HP J8999A Manuale utente
