7
6. Aaching Your Display to The Wall Plate: Aer installing the wall plate and tesng to ensure that it is aached
securely and aaching the arms to the back of the display, it is me to aach your display to the wall. This step may
require two people, aach the hook to the top lip of the wall plate. Once the hooks are securely set onto the wall plate
you can now let the boom of the display rotate back and it will simply hang on the mount.
7. Securing Your Display: The mount ulizes a set screw aached to the
boom of each one of the arm brackets. To secure the arm bracket to
the TV plate, locate the set screw on the boom of the arm then ghten
in a clockwise moon unl ght. This screw ensures that your display
will not li off of the mount.
8. Adjusng Your Tilt: To adjust the lt posion on your display you will
need to loosen the Phillips screw on the side of each one of the arm
brackets, set the desired lt and then ghten the arms back up. You can
loosen the screws slightly so that it will sll hold while you adjust your
lt, once you have set the desired angle of lt you can then fully ghten
the screws.
Secon 2: Concrete and Masonry Installaon:
1. Mark Installaon Points: Once you have selected the
locaon you want the mount to be, mark the exact locaon
where the anchors and lag bolts will be installed. Next, pre-
drill the holes using a masonry 10mm drill bit to a depth of 2”
then insert the supplied anchors. If you do not have a metric
drill bit a 3/8" drill bit will work.
Drilling Into Concrete: When drilling into concrete or masonry,
you have to use a special masonry drill bit which you can
purchase at your local hardware store, using a standard drill bit
will not penetrate the concrete and it will just dull your drill
bit. It is not recommended to drill and mount into concrete block or mortar joints. If mounng into concrete or
masonry we recommend using all of the supplied plasc anchors and lag bolts for maximum support. The supplied
plasc anchors are rated for use up to 165LBS, but if you prefer you can go to your local hardware store and purchase
metal concrete anchors.
2. Aaching The Mount to Your Wall:
Once the holes are pre-drilled, insert all plasc anchors,
Then affix the wall plate with the four supplied lag bolts and
washers into the wall.
Revision date: 04/12/2016
