VANGUARD ALARM
4 5
Register online to validate your
warranty for your Vanguard alarm
www.movingintelligence.co.uk/vanguard
4 Tilt sensor exclusion*
Arm the alarm as usual by pressing button 1. After the
usual two beeps wait 4 seconds and press button 3.
Tiltsensorexclusionisconrmedbyonebeep.
5 Awning Light*
Arming/Disarming the alarm will activate the awning light for
30 seconds. Button 4 on the remote will also activate the light
for 5 minutes before automatically turning o.
*Typically awning light control will only be possible with factory installations.
DISARM
2
ARM
PET MODE/
NIGHT MODE
1
3
AWNING/
DOME
LIGHT
4
*Please note: Sensor exclusion is bound to a single arming cycle. Sensors
will automatically be enabled the next time the alarm is armed
6 Tilt sensor adjustment
The TILT sensor sensitivity level is factory set to trigger
an alarm if the vehicle is tilted at an angle of approx. 1.5°
with respect to the x, y and z-axis.Sensor sensitivity can
be custom-adjusted :
(every time you enter in ‘Adjustment Mode’, the sensitivity level will
automatically be restored to the 1.5° default setting).
Disarm the alarm system.
Simultaneously press, twice in a row, remote control buttons 1 and 2:
2 ‘Bops’ will conrm the system is in ‘Adjustment Mode’
Press button 2 once to increase the tilt angle to 3.5°:
operation will be conrmed by 1 beep.
Press button 2 again to increase the tilt angle to 7°:
operation will be conrmed by 1 beep.
Press button 2 once more to increase the tilt angle to 14°:
operation will be conrmed by 1 beep.
The system will automatically exit the adjustment mode after
this step. 1 ‘BOP’ will conrm the end of the procedure.
To exit the adjustment procedure and conrm the selected tilt
angle, simultaneously press remote control buttons 1 and 2
COLLECTION
