Install bit and select direction of rotation.
NOTICE: Do not change direction of rotation while Chuck is rotating. Wait until
Chuck has come to a complete stop before changing direction.
Press Trigger to start the tool. The Work Lights will turn on when Trigger is
pressed and turn off a few seconds after Trigger is released.
The tool has variable speed. To increase speed, apply more pressure to Trigger.
To decrease speed, lessen pressure on Trigger.
Tighten or loosen the fastener(s) as required.
Note: The amount of actual torque will vary depending on the cleanness and
condition of the threads and other factors. If tightening critical components,chase
threads before assembling components and check the actual torque applied to the
fastener with a mechanical torque wrench (not supplied).
When finished using the Impact Driver, release Trigger and center Direction Switch
to lock Trigger.
To prevent accidents, turn off the tool and remove its Battery Pack after use. Clean, then
store the tool indoors out of children’s reach.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your
local dealer. If the problem continues after troubleshooting, call your local dealer for
assistance.
