Page-5 www.multispanindia.com
PIC-6004A
1) All safety related codifications, symbols and instructions that appear in this operating manual or
on the equipment must be strictly followed to ensure the safety of the operating personnel
as well as the instrument.
2) If all the equipment is not handled in a manner specified by the manufacturer,
it might impair the protection provided by the equipment.
3) Read complete instructions prior to installation and operation of the unit.
1) To prevent the risk of electric shock power supply to the equipment must be kept OFF while doing
the wiring arrangement.
2) Do not touch the terminals while power is being supplied. To reduce electromagnetic interference,
use wire with adequate rating and twists of the same of equal size shall be made with shortest
connection.
3) A better anti-noise effect can be expected by using standard power supply cable for the
instrument.
1) Do not allow pieces of metal, wire clippings, or fine metallic fillings from installation to enter the
product or else it may lead to a safety hazard that may in turn endanger life or cause electrical
shock to the operator.
2) Use and store the instrument within the specified ambient temperature and humidity ranges
as mentioned in this manual.
3) Prior to the installation of this product, the installation instructions must be read and completely
understood. Keep these installation instructions in an easily accessible location for future reference.
Proper installation procedure by a qualified service technician must be followed, as outlined in
these installation instructions. Failure to do so could result in property damage, serious personal
injury, or even death.
4) Safety measures must be practiced at all times during the assembly of this product.
5) Use proper safety equipment and tools for the assembly procedure to prevent personal injury
Be aware of the mounting environment.
6) If drilling and/or cutting into the mounting surface, always make sure that there are no electrical
wires in wall.
7) Cutting or drilling into an electrical line may cause serious personal injury.
8) Make sure there are no water or natural gas lines inside the wall where the mount is to be located.
9) Cutting or drilling into a water or gas line may cause severe property damage or personal injury.
10) Do not install near sources of high heat. Do not install on a structure that is prone to vibration,
movement or chance of impact.
Risk of electric shock, Hazard Warning
!
1) The equipment should be cleaned regularly to avoid blockage of ventilating parts.
2) Clean the equipment with a clean soft cloth.
3) Do not use isopropyl alcohol or any other cleaning agent.
4) Fusible resistor must not be replaced by operator.
Safety Precautions
Warning Guidelines
Installation Guidelines
Maintenance
