If you use an extension socket board with this device, take care to
ensure that the total power consumed by the connected equipment
does not exceed the maximum permitted power consumption for the
extension socket board.
Also take care to ensure that the total power consumed by the
equipment connected to a wall outlet does not exceed the maximum
permitted power consumption for the affected wall outlet.
Do not attempt to service the device yourself.
Contact the ACS Helpdesk.
Isolate the device from mains power and request servicing from a
qualified service technician, if any of the following scenarios occur:
- The power cable or mains plug is damaged
- Liquids have leaked into the device
- The device has suffered a fall or its housing is damaged
- The device is not working properly or its performance is impaired
If the printer is operated within Germany, please observe the
following:
- The building’s electrical installation must be protected using a
circuit breaker (10 A or 16 A), so as to ensure an adequate level of
protection against short-circuiting and overvoltage.
- If the mains plug has become damaged, replace the cable set or
contact a qualified technician. Possibly installed fuses may only be
replaced with fuses of the same size and the same nominal value.
- If you use a cable to connect the printer to a computer or a
different piece of equipment, check to ensure the proper
alignment of the plug connectors. Each connector can be plugged
only when aligned in a certain way. If you try to plug a connector
when it is wrongly aligned, then both pieces of equipment
connected by the cable may be damaged.
