6. Installation Procedures
© MuxLab Inc. 2023 6 94-001012-A/SE-001012-A
KVM HDMI over IP PoE Extender Deluxe, 4K30
Identification of Connectors:1.
Identify connectors on the Transmitter and Receiver based on product labels.
Refer to front and rear product views for connector details.
Distance Verification:2.
Verify that the distance between HDMI Transmitter and Receiver complies with
MuxLab specifications.
Transmitter Installation:3.
Connect Transmitter to computer server/workstation HDMI video source using an
HDMI-compliant cable.
Connect Transmitter USB Port to computer server/workstation USB port using a
compliant Type A to Type C USB Cable.
Connect computer audio-out to Transmitter audio-in if required.
For point-to-point application, connect one Cat 5e/6 cable to the RJ45 LAN
connector on the Transmitter.
If transmitting over the network, use an Ethernet Switch between Transmitter and
Receiver.
Receiver Installation:4.
Connect Receiver HDMI port to Monitor HDMI port using an HDMI-compliant cable.
Connect two Receiver USB 1.1 ports to a USB keyboard and mouse.
Connect two Receiver USB 2.0 ports to other USB devices (printer, drawing pad,
storage device, etc).
Connect Receiver audio-out to amplified speaker if required.
For point-to-point application, connect one Cat 5e/6 cable from the Transmitter to
the RJ45 LAN connector on the Receiver.
If transmitting over the network, use an Ethernet Switch between Transmitter and
Receiver.
Multiple Point-to-Point Configuration:5.
Use an Ethernet Switch with Gigabit ports, DHCP Server, and Jumbo Frame support.
Verify correct configuration of the Ethernet Switch, enable DHCP Server, and enable
Jumbo Frame.
Connect all Transmitters and Receivers to the Ethernet Switch.
Use the Up and Down buttons located on the right side of the display to assign a
unique device ID for each transmitter.
Configure each Receiver Device ID to correspond with the selected Transmitter.
Skip this step if using MuxLab ProDigital Network Controller (500812).
IR and RS232 Ports:6.
The Transmitter and Receiver support bi-directional IR and RS232 ports for control
signals if required.
