µ
WMF coffee machines planning information 1200 S
These specifications for the electrical connection and the standards quoted apply for
connecting the coffee machine in EU countries. It may be necessary to also observe additional
country-specific regulations. Outside the EU countries acceptance of the standards quoted is
to be checked by the legal entity or natural person who wishes to use the coffee machine. The
local power supply must be constructed according to the currently valid IEC 364 (DIN VDE
0100). To improve safety, the device should be fitted with an FI 30 mA earth leakage current
circuit breaker complying with EN 61008. (Type B residual current circuit breakers provide
reliable tripping even if the fault current is smooth. This ensures a high level of safety.) Near
the device or about 30 cm below the counter top there should be a shockproof socket as a
single-phase connection installed locally on the rear or side wall of the counter substructure
or a country-specific single-phase socket. If the mains cable for this device is damaged then it
must be replaced by our service personnel or a similarly qualified person, in order to prevent
hazards.
Important advice regarding accounting systems:
In case of operation with a card reader an additional and separately fuse-protected
shockproof socket must be installed onsite if necessary depending on type of card reader. The
supplier of the card reader is to be asked for the required fuse protection. In order to prevent
possibly occurring disturbances of our screened data lines by potential equalization currents
between the units, an additional potential equalization according to VDE 0800-2 should be
provided for units connected to an accounting system.
Water supply
and drainage
The water supply must be located close to the machine (max. distance 800 mm). An anytime
easily accessible and sufficiently dimensioned water tap (preferably ball tap) as well as a dirt
filter with mesh size 0,080 mm must be installed below the counter in the water supply. If the
coffee machine is connected to a drain connection, a siphon must be installed in the drain
pipe. (Fit hose connection in funnel with hose ring mount.) For connection from below
through the counter a cut-out must be made in the hatched area according to drawing (see
top view). For drinking water with carbonate hardness above 5°dKH (carbonate hardness), a
WMF water filter should be fitted upstream.
+5 °C to maximum +35 °C
(empty the water system in case of frost)
80 % relative humidity without condensation. Do not use device
outdoors.
0.05 kWh/h standby mode
12.045 kWh/h maximum use
Continuous sound
pressure level (Lpa)
For more information as the instruction manual , safety data sheets and certificates , see:
http://www.servicecenter.wmf.de/
All information refers to coffee machines/ equipment as standard version. Individual solutions can differ from the
standard version.
http://www.wmf-kaffeemaschinen.de/fachplaner
WMF Group GmbH | Eberhardstraße 35 | 73312 Geislingen (Steige)
