W415-0656 / C / 10.19.11
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
AK8 AND GICSK
INSTALLATION INSTRUCTIONS
FOR MODEL NPI-40
Included in the AK8 kit:
ITEM # PART# DESCRIPTION QTY
1 W263-0096 Top Flashing 1
2 W263-0098 Left Flashing 1
3 W263-0097 Right Flashing 1
4 W385-0334 Napoleon Logo 1
W570-0001 Screw, #8 x 3/8" 2
W570-0006 Screw, #8 x 1/2" 4
W570-0020 Screw, #8-32 x 3/8" 4
W735-0026 Lock Washer, #8 4
W450-0008 Nut, #8-32 Hex 4
1. Secure the Right Flashing to the right side of the unit using two
of the #8 x 1/2" screws. NOTE: Feed the Air Control Rod into
the Air Control Slot on the Right Flashing before securing.
(FIGURE 1)
FIGURE 1
RIGHT
FLASHING
AIR
CONTROL
ROD
CONTROL
PANEL
AIR
CONTROL
SLOT
BURN
RATE LABEL
LOW
HIGH
1
2
3
4
5
1 1/2”
TOP
FLASHING
FIGURE 3
FIGURE 2
PUSHTO START / POUSSEE POUR COMMENCER
W385-0355
5
3
1
2
4
OPTIMUM
1
35
4
2
SHIPPING
BRACKET
SECURING
SCREWS
CONTROL
PANEL
SECURING
SCREWS
AK8 INSTALLATION
2. Twist spring handle (supplied with the heater) onto the air
control rod until it hits the stop.
3. Remove the two control panel securing screws, discard the
screws and shipping bracket.
(FIGURE 2)
4. Secure the control panel to the Right Flashing using the two
#8 x 3/8" screws. (FIGURE 2) Secure the Left Flashing with the
remaining #8 x 1/2" screws.
5. Align the holes in
the top of the Right
and Left Flashing
with those on the
bottom lip of the Top
Flashing and secure
from the rear using
the four #8-32 x 3/8"
screws, washers and
nuts.(FIGURE 3)
6. Affix the burn rate
label under the slots
on the right flashing 1 1/2" in from the inside edge, with the word
"LOW" to the left. (FIGURE 1)
Shown with AK8 and GICSK installed
1
2
4
3
5
4
3
2
1
LOW
HIGH
GICSK INSTALLATION
Refer to steps #11 and #12, as well as all warnings, in the
instructions included with your GICSK kit for installation.
NOTE: Affix the logo to the bottom left hand corner
of the left flashing after the GICSK has been installed.
