Method C: By Smart Mobile Devices
Method A: By Routers Support WPS Method B: By Routers Do Not Support WPS
WI-FI CONFIGURATION GUIDE
Step-1: Plug the wireless adapter to BDG-256
gateway, and wait for several seconds.
Step-2: Press the WPS button on the router for
2 seconds, and for most routers, the WPS
button would flash at this point.
Step-1: Connect the BDG gateway to a router with a cable, and a few seconds later,
an IP address will appear at the bottom of the BDG-256 screen;
Step-2: Log on to the webpage: http://BDG_IP/wifi (BDG-IP refers to the IP shown at
the bottom of BDG-256 screen, e.g. 10.208.32.52).
Step-3: Set Wi-Fi parameters.
Wireless
Adapter
Step-3: Within 2 minutes, return to the BDG-256
gateway, click on Setting/Ethernet, and press
“WPS” (the red button). If the gateway reports the
WPS setup is successful, the IP address on the
gateway screen will be updated instead of 0.0.0.0
within 5 minutes.
Step-1: On an iPhone, click on Settings/General/About. Input
name “MI Installer”
Step-2: Turn on “Personal Hotspot”, and input Wi-Fi Password
“my-gateway”. This password is for other devices such as the
BDG-256 gateway to connect to this mobile device.
Step-3: On the BDG-256 gateway, click on Setting/Ethernet, and
choose “Connect to Mobile” or “Link to Mobile” (the green button).
Step-4: If the connection has been set, a flashing banner “Personal
Hotspot: 1 Connection” will appear at the top of the iPhone screen.
Step-5: Continue from Step-3 of Method B.
Step-6: After using the hot-spot communication, Wi-Fi setup can
be restored, if the Wi-Fi configuration in BDG-256 gateway is not
changed by hot-spot link. First hit on the button “Disconnect from
Mobile” (see Step-3), and then reboot the gateway, then the Wi-Fi
connection will be restored.
NOTE:
1. set the name of the hotspot
link as “MI Installer”
2. set the password of the
hotspot link as “my-gateway”
Enter the password “gateway” Set WLAN parameters and save your settings
Wireless Network Setup Wireless Network Setup
SSID: The name of the home wireless network.
Security type: The wireless adapter supports several security protocols. Please refer
to the wireless router user’s manual for suitable type (default one works for most
routers).
Password: The password for home wireless network.
DHCP: If yes, the wireless router will assign an IP to the gateway. This is most
commonly used (no need to change unless for advanced users).
IP: If DHCP is set to “NO”, users could fix an IP to the gateway. This function is only for
advanced users, who should be responsible for confliction with other network devices
if this IP address is not set properly.
Step-4: plug in the wireless adapter, and then reboot gateway.
If Wi-Fi is connected, a signal
strength bar at the left upper
corner and an IP address at the
bottom should be notified.
