Disassemble Procedure
Standard Mounting Method
Accessories
Description Model Size (unit:mm) Suitable For Weight
Armature plate NEMLA2 192L x 72W x 17H Wooden door and doors with thick door frame 0.22kg
L Bracket NEMLB5
NEMLB5B 264L x 70W x 42H Narrow door 0.58kg
LZ Bracket NEMLB6
NEMLB6B
Z: 185L x 60W x 60H
L: 265L x 70W x 42H Inward-opening, narrow frame and metal doors 1.3kg
Disassemble the cover and band before installing the lock.
The following accessories are compatible with Neptune 500 series maglocks:
1. Unfasten the screw
and open the cover.
2. Unscrew the anti-disassemble
bolts with the hex key.
3. Use the allen key to loosen the
screws of the mounting plate.
4. Remove the mounting plate
from the lock body.
Mounting plate
Hexnut bolt
Door spacer
Rubber
washer
Armature
screw
1. Use the supplied template to determine the correct location and size of mounting holes for both the door and frame header. Ensure that the door
opens away from the maglock. In the case of a single door, the maglock is positioned as close as possible to the vertical section of the door jamb.
Drill door and frame as indicated.
2. Loosely install the mounting plate using two of the supplied Philips head mounting screw in the elongate slots. Attach the maglock to the mounting
plate.
3. Using a hammer, lightly tap both roll pins into the armature plate until they are secure.
4. Before install the hexnut, the hole in the door may need to be driller or tapper. Make sure the that the armature plate is not over tightened and that it
is installed as shown in the following diagram. The armature plate must be free to self-align with the door.
5. Ensure the armature and magnet are aligned. Adjust the mounting plate to suit and then drill the appropriately sized holes in the door header for the
remaining attachment screws.
6. Close the door to test holding force. The angle between the armature plate and magnetic lock can be adjusted by adding or reducing washers.
Warranty
Neptune Security Products warrants that this product to be free from defects in materials and workmanship for a period of ve (5) years from date of
purchase. In the event of failure, Neptune Security Products will replace (if product is within rst year of warranty period) or repair (during years’ one to
ve of warranty period) the product at its sole discretion, and will not be responsible for any loss or damages in association with uses of its products.
This warranty does not apply in the event of accidental damage and improper use, abuse, misuse, non approved purpose or act of God.
