Netronix W433D Manuale utente

IEEE802.11n Wireless Router

W433D

User Manual

Version: 0.2

Date: May 21, 2008

FCC Certifications

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End

users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain

compliance with FCC RF exposure compliance requirements, please follow operation instruction as

documented in this manual.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

iii

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

CE Mark Warning

This equipment complies with the requirements relating to electromagnetic compatibility, EN

55022 class B for ITE, the essential protection requirement of Council Directive 89/336/EEC on

the approximation of the laws of the Member States relating to electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it may be possible that information

in this document is not up-to-date. Please check with your local distributors for the latest

information. No part of this document can be copied or reproduced in any form without written

consent from the company.

Trademarks:

All trade names and trademarks are the properties of their respective companies.

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、

加大功率或變更原設計之特性及功能。

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停

用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。

低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Table of Contents

UNPACKING INFORMATION ···························································································· 7

INTRODUCTION TO WIRELESS ROUTER······································································· 7

General Description····································································································· 7

Key Features··············································································錯誤! 尚未定義書籤。

The Front Panel···········································································································8

The Rear Panel ···········································································································9

Placement (Optional)··································································································· 9

INSTALLING AND USING WIRELESS ROUTER···························································· 10

Connecting this Router to your network····································································· 10

Configuring the IP address of your computer ···························································· 10

MANAGEMENT················································································································ 13

Starting the WEB-Based Management Interface ······················································· 13

The Graphic User Interface ······················································································· 14

Operation Mode········································································································· 15

Network Setting ········································································································· 15

WAN Interface Setup·························································································· 15

LAN Interface Setup··························································································· 23

QoS Settings ······································································································25

Wireless Settings······································································································· 27

Basic Settings······································································錯誤! 尚未定義書籤。

Advanced Settings······························································································ 27

Security Settings································································································· 30

WDS Settings····································································································· 34

WPS Settings ····································································································· 36

Access Control ··································································································· 38

Firewall Settings ········································································································ 40

IP / Port Filter······································································································ 40

MAC Filter ·········································································································· 42

Layer7 Filter ······································································································· 43

Virtual Server······································································································ 44

Virtual DMZ········································································································· 45

DoS Protection ··································································································· 46

Services Settings······································································································· 47

DDNS Settings ··································································································· 47

Date/Time Settings····························································································· 48

Management·············································································································· 49

Admin Account···································································································· 49

Config················································································································· 50

Firmware Upgrade······························································································ 50

Information················································································································· 51

System Information····························································································· 51

Packet Statistics ································································································· 52

System Log ········································································································52

Logout························································································································ 53

Logout ················································································································ 53

Reboot················································································································ 53

PRODUCT SPECIFICATIONS ························································································· 54

Unpacking Information

Thank you for purchasing the product. Before you start, please check all the contents of

this package.

The product package should include the following:

1. One Wireless Router

2. One power adapter

3. One Quick Installation Guide

4. One User Manual (CD)

5. Three antennas

Introduction to Wireless Router

General Description

The IEEE802.11n Wireless Router is compatible with IEEE802.11n draft 2.0 standard,

which supports data rate up to 300 Mbps in 2.4 GHz band, which is also compatible

with IEEE 802.11b/g wireless devices. The router allows multiple users to share one

broadband connection, as well as secures your private network. With its built-in 4-port

switch and wireless AP, LAN users can share files, printers, or playing network games

all at a blazing speed.

To provide a secure wireless network, this router supports wireless data encryption with

64/128-bit WEP, WPA and WPA2. Network Address Translation (NAT) Firewall is also

support to shield your communications and network from hackers and wireless

eavesdroppers.

The Wireless Router built-in with 4-port 10/100Mbps Fast Ethernet Switch is the latest

generation of Wireless router product for Home/Office and SOHO users. This

full-feature and self-contained compact Wireless Router will be fully for broadband

access in both of LAN and Wireless environment. This device has been specifically

designed to provide LAN and Wireless users the most cost-effective method with

multiple accesses to the Internet at the cost of a single public IP address（IP Sharing）

and enjoy the true Plug-and-Play installation. Moreover, the built-in 4-port 10/100Mbps

switch lets users plug the network cable into the device without buying additional

switch.

This device is also an Access Point. It has a built-in wireless LAN. Users can connect to

Internet using wireless network interfaces anywhere within the range of its radio

transmission. It’s ideal for SOHO users who require instant and convenient access to

Internet without the restriction of connecting cables.

The Front Panel

The front panel of the Wireless Router:

LEDs Definitions

zStatus LED

The LED will be dark for a few seconds when the system is started. After that, the LED

will blink periodically to show the Wireless Router is working normally. If the LED stays

green/dark that means the system failed, you need to contact your agent or try to

reboot the system.

zWLAN LED

When Wireless Router is ready for data transmitting and receiving, it is steady green.

zLAN LEDs

Every port has an Act/Link LED. Steady green (link state) indicates that the port has

good linkage to its associated devices. Flashing green indicates that the port is

receiving or transmitting data between its associated devices.

zWAN LED

The LED stays light (green) means the WAN port has good linkage to its associated

devices.

The LED will blink green when there is traffic transverse the port.

zEZsetup Button1

EZsetup button helps out users to connect this Router to Internet quickly. It uses Push

Button Communication (PBC) method, in which users can simply push this button to

easy setup WPS connection. Please refer to WPS settings for more information.

1This button may not supplied depend on your model. Users can select the PBC mode in the WPS settings web page

to reach the same function.

The Rear Panel

The rear panel of the Wireless Router is shown below.

Power Connection

Plug the circle end of the power adapter firmly into the rear panel of the Wireless Router,

and the other end put into an electric service outlet then the system is ready.

Restore Default Button

1. Push the button for more than 5 seconds and then release it, the system will return

to factory default setting. In the meantime, system rewrites flash to default value and

Status LED halts for a while. Approximately 60 seconds later, the Status LED blinks

green periodically, now the whole system parameters have returned to factory

default value. If the process has been interrupted by any reason (power off…), the

system will fail. Before performing the process, ensure a safe operating environment

please!

2. To reboot the Router, press the button for 2-5 seconds and then release it, and all

the setting won’t be erased. Wait for the Router to complete the reboot, and then

you can start to use it.

Placement (Optional)

There are three ways to place the Router. The first way is to place the Router vertically

on a surface. The second way is to attach it to a magnetic surface. The third way is to

attach it to the wall. If you select a wall-mount option, please follow the steps below:

1. Select a location with access for cables and a power outlet.

2. Unplug the unit. Place it upside down on a flat surface and mark the two holes for

anchors.

3. Installing the wall mount anchor (not supplied) into the wall with tools such as drill or

hammer.

4. Insert the screws (not supplied) in each hole of the stand parts.

5. Attaches the unit to the anchors on the wall.

Warning：Incomplete factory setting recovery procedure will cause the Wireless Router

malfunction！If you are unfortunately in this situation, do not try to repair it

by yourself. Consult your local distributor for help!

Installing and Using Wireless Router

This chapter provides a step-by-step guide to the installation and configuration of the

Wireless Router. We suggest you go over the whole chapter and then do more advanced

operation.

Connecting this Router to your network

Steps to build up the network:

¾Connect the ADSL or Cable modem to the Ethernet WAN port on the back of the

Wireless Router by using the UTP cable.

¾Connect the phone line from the wall socket to the line-in port on the ADSL modem,

or the coaxial cable to the line-in port on the Cable modem.

¾Plug-in the power adapter to the modem and turn on the power. Install the Ethernet

card into the computer by referring to the User Guide that came with the card.

¾Connect the computer to the Wireless Router by using standard twisted-pair Ethernet

cable from the computer’s Ethernet card to a 10/100Mbps Ethernet port on the back

of the Wireless Router.

¾Plug-in the power adapter to the Router and the other side to the wall outlet.

Configuring the IP address of your computer

In order to communicate with this Wireless Router, you have to configure the IP

addresses of your computer to make it compatible with the device. The router supports

DHCP server and it is enabled as default. Users that configure your IP address as

“Obtain an IP address automatically” may skip the following IP configuration

instruction.

Note:

1. The default network setting of the device:

IP address: 192.168.1.1

Subnet Mask: 255.255.255.0

DHCP Server: enable

2. In the following TCP/IP configuration guide, the IP address “192.168.1.2” is

assumed to be your IP address if you want to specify IP addresses manually.

Please DO NOT choose “192.168.1.1” as the IP address. For the IP address

“192.168.1.1“has been set as the default IP for this device.

3. The following TCP/IP configuration guide uses windows XP as the presumed

operation system.

Indice

Manuali Router wireless popolari di altre marche

Milesight

Milesight UG67 Manuale utente

Airlogic

Airlogic AirSync Class 1 Manuale del proprietario

Samsung

Samsung WCH730B Manuale utente

TELEFONICA

TELEFONICA USB Adapter Manuale utente

NETGEAR

NETGEAR PowerLINE WiFi 1000 Series Manuale utente

Askey

Askey RAC2V1K Manuale utente

Alloy

Alloy WLF2454AP-S Manuale utente

TP-Link

TP-Link TL-WR542G Manuale utente

NETGEAR

NETGEAR WNR2000v4 Manuale utente

Hama

Hama 53120 Manuale utente

Intellinet

Intellinet 524582 Manuale utente

Asus

Asus RT-N10P Manuale utente

D-Link

D-Link DIR-506L Manuale utente

Sapido

Sapido GR297n Manuale utente

Asus

Asus DSL-N55U Manuale utente

AMTC

AMTC WR7502 Manuale utente

Compaq

Compaq CP-2W - iPAQ Connection Point Manuale utente

SMC Networks

SMC Networks WBR14-N2 FICHE Manuale utente