Eth1 is a special port only used for monitoring but requires a valid IP address that is not found on the network. A
suggestion is to use 1.1.1.1/255.255.255.255.
Note: If the IP Address for Eth0 or the SSL Port has changed, the appliance will restart.
•Hostname - assign a valid and relevant host name.
•SSL Port - default port is 443 which can be changed according to the network setup.
•Default Gateway - usually, the IP address of the router.
•DNS Server - DNS IP Addresses (e.g. 8.8.8.8, gateway IP address, ISP given DNS).
•Interface - Select the interface to be configured.
•VLAN - VLAN alias of the interface (e.g. office, finance, department) if used.
•VLAN Tag - a numerical value of the VLAN where the said interface belongs to. (e.g. 10, 20) if used.
•IP Address - a valid IP address of the interface (e.g. 192.168.10.10).
•Subnet Mask - network address of the IP address/interface (e.g. 255.255.255.0).
Sixth Tab: Notification Setup - configure the email notification by filling up the required
information marked with red asterisk, and then click Save.
