Indoor Receiver
Remove the battery cover and insert 2x1.5V AA batteries, making sure to
correctly match the polarities as marked.
The receiver can be attached to a wall using the provided screw and wall
plug or can be left free standing. Avoid positioning on UPVC frames,
above heat sources (e.g. radiators) or in damp areas such as a kitchen or
bathroom.
Melody Selection
Use the melody selection button on the side of the receiver to cycle
through the various pre-programmed melodies for the chime.
Volume Adjustment
Use the volume adjustment button on the side of the receiver to select
Low, Medium or High volume setting.
Auto Learning
The outdoor unit sends wireless signal to the indoor receiver. The indoor
receiver will automatically register and memorise the signal as an
operation code. The outdoor unit will then work with the indoor receiver.
Auto Learning Code Set Up
The indoor receiver is equipped with an auto learning function.
1. To pair one outdoor and one indoor unit, simply connect the outdoor
unit to the power and insert the batteries into the indoor unit. Press
the bell on the outdoor unit and the indoor unit will sound to
indicate that the two are paired.
2. To pair additional outdoor units to a single indoor receiver, with all
units powered on, press the bell button on the outdoor units within
15 seconds of each other to pair both outdoor units. The indoor
receiver will sound when paired. (If the outdoor buttons are not
pressed within 15 seconds of each other only one outdoor unit will
be paired. Simply follow the pairing process and make sure that both
units are pressed within 15 seconds.)
3. If you experience interference from other nearby equipment,
remove the batteries from the indoor receiver and leave for 30
seconds to reset. Re-insert the batteries and repair the receiver as
described in step one.
4. The indoor receiver can pair with a maximum of 5 outdoor units.
