L=Brown
E=Yellow/Green
N=Blue
influence service life of lamp, and damage components of circuit board. After
finish it, please strengthen the metallic gobo flag and heat guard of two sides of
lamp firstly. Then using adhesive tape to fold covering shell, and strengthen
screws of right-and-left of it.
NSK light products are provided with high voltage modulator tube what has
exterior igniter. When operate these modulator tubes, it must be careful, and
should read the instruction of modulator tube that offer by manufacturer before
operation.
Warning 1: Don’t forget install metallic gobo flag and heat guard that beside
the lamp or thermal radiation is easy to bake the plastic shell distortion. Seriously,
it will raise fire alarm. Manufacturer will not responsible for these losses.
Warning 2: Modulator tube will reach to a high temperature when it works,
and the trait of gas discharge lamp can not intermittent power supply. It must cool
at least 15 minutes to work again after power supply cut off, or it will induce high
pressure discharge, short
circuit, and even burn out parts of computer control panel.
3. Power supply.
Using appropriative plug connect computer light and power main lead. Pay
attention to consistent of voltage, frequency and supply source of backboard of
computer light. Suggest each computer light to use a separate power supply, so
each light can be turn on and turn off at will.
Important matters:
Each computer light should be earthed and whole electro assembling must
accord with standard demand.
The power consumption of computer light is 300W.
Monitoring restoration system:
After computer light switch on power, circuitry will be install. This function
makes lamp cobra moving to a limiting position, and it will turn interior color and
superimposed wheel of pattern. Thus the control system of microprocessor can
