4
LED Status Lights
The front panel LED lights are shown below and explained in the following table.
This information can be used to check the status of the device and its
connections.
LED Colour Mode Function
POWER
GREEN On The device is powered up.
Off The device is powered down.
RED On
POST (Power On Self Test) failure or other malfunction. A
malfunction is any error of internal sequence or state that
will prevent the device from connecting to the DSLAM or
passing customer data.
ETH WAN
GREEN
On WAN is connected at 1000 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 1000 Mbps.
YELLOW
On Ethernet is connected at 10/100 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 10/100 Mbps.
ETH 4 to 1
GREEN
On Ethernet is connected at 1000 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 1000 Mbps.
YELLOW
On Ethernet is connected at 10/100 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 10/100 Mbps.
WiFi 2.4G GREEN
On The wireless module is ready. (i.e. installed and enabled).
Off The wireless module is not ready. (i.e. either not installed
or disabled).
Blink Data transmitting or receiving over WLAN.
WiFi 5G GREEN
On The wireless module is ready. (i.e. installed and enabled).
Off The wireless module is not ready. (i.e. either not installed
or disabled).
Blink Data transmitting or receiving over WLAN.
INTERNET
GREEN
On
IP connected and no traffic detected. If an IP or PPPoE
session is dropped due to an idle timeout, the light will
remain green if an ADSL connection is still present.
Off
Modem power off, modem in bridged mode or ADSL con-
nection not present. In addition, if an IP or PPPoE session
is dropped for any reason, other than an idle timeout, the
light is turned off.
Blink IP connected and IP Traffic is passing thru the device
(either direction).
RED On
Device attempted to become IP connected and failed (no
DHCP response, no PPPoE response, PPPoE authentication
failed, no IP address from IPCP, etc.)
