© 2020 Nexmosphere. All rights reserved. v1.0 / 12-20
All content contained herein is subject to change without prior notice
Nexmosphere
Le Havre 136
5627 SW Eindhoven • The Netherlands
T+31 40 240 7070
Esupport@nexmosphere.com
The X-Eye Motion sensors provides the following functionalities:
1. Detect motion - detect motion within its detection eld
This information is translated into an API message which has
the following format:
X001A[X]
When the sensors detects motion - typically when a
person moves within its detection eld - the sensor will
trigger an API command indicating the amount of motion
which was detected. When applying these commands,
please consider the following:
• The higher the number, the higher the amount of
motion detected. When no motion is detected, the
output will be 0.
• The amount of motion is a determined by the size,
velocity and direction of the object or person which
is moving. Please see section 4, page 3 for more info.
• The detection area/range of the motion sensor can be
adjusted. Please see section 5 "Settings", page 5.
The following section will cover this functionality in detail. Please note that for each API example in this document,
X-talk interface address 001 is used (X001). When the sensor is connected to another X-talk channel, replace the
"001" with the applicable X-talk address.
Example commands
Motion detected, amount of motion is "4"
Motion detected, amount of motion is "12"
Motion detected, amount of motion is "23"
No motion detected (amount of motion is "0")
X001A[4]
X001A[12]
X001A[23]
X001A[0]
X= amount of motion value between 0-50
When integrating an X-Eye Motion sensor into your digital signage installation, several installation requirements and guidelines
need to be taken into account in order for the sensor to perform optimal and operate stable.
The X-Eye Motion sensor can be connected to any X-talk interface and is therefore compatible with all Xperience controllers.
Make sure the X-Eye Motion sensor is connected to the X-talk interface before powering the Xperience controller. Otherwise,
the X-Eye Motion sensor will not be recognized by the Xperience controller and no sensor output will be provided.
XN
transceiving side
X-Eye
DC Power supply
XC
transceiving side
X-Eye
Example connection to XC Controller Example connection to XN Controller
2
