3 USE OF THE CONTROL UNIT
To control the loads via radio you must have compatible transmitters and therefore must carry out the association
procedure, see paragraph 4.
If the transmitter is of a generic type, its operation is:
If the transmitter is multifunctional type, its operation is:
3.1 USE VIA RADIO
The device is set up to accept commands via wire by button in terminals 3 and 4.
Should you want to control the load only via radio, it is not necessary to connect these devices for the
control unit to work properly.
The behaviour of the different keys is shown in the following table:
3.2 USE VIA WIRE
Short press
Long press
Button of the
transmitter
Action of the
control unit
Close and reopen the contact
Holds close the contact until the release of the button
Short press
Long press
Button of the
transmitter
Action of the
control unit
Close and reopen the contact
Holds close the contact until the release of the button
No action
No action
Short press
Long press
Input
(P1=P2)
Action of the
control unit
Close and reopen the contact
Holds close the contact until the release of the button
4.2 DELETION OF TRANSMITTERS
These procedures let you delete from the memory transmitters that have already been programmed.
DELETION OF SINGLE TRANSMITTER:
1- Hold the receiver button down for 8 seconds. The LED begins to flash.
2- Make a transmission with the transmitter that you want to delete. The LED flashes quickly and turns off.
DELETION OF ALL THE SAVED TRANSMITTERS:
1- Hold the receiver button down for 8 seconds. The LED begins to flash.
2- Press the button on the receiver for a short time. The LED starts flashing quickly and turns off.
4.1 RADIO PROGRAMMING OF MULTIFUNCTIONAL
AND GENERIC TRANSMITTERS
4 - RADIO PROGRAMMING
This procedure lets you programme only compatible multifunctional transmitters (see table 4.1a) or
generic (see table 4.1b) transmitters.
PROCEDURE:
1- Press the button on the receiver for a short time. The LED comes on and stays on.
2- Make a transmission with the remote control to be saved (see transmitter manual, the paragraph
entitled "transmitter programming"). The LED on the receiver flashes 3 times to signal that it has been received.
3- The control unit listens for 30 seconds
(to immediately exit the procedure pressthe button on the receiver).
Tab. 4.1a
HB70-SLCT, HB70-SPCT,
HB80-1C, HB80-1DIM, HB80-2L, HB80-30D, HB80-30RGBW, HB80-4C, HB80-4DIM, HB80-4L,
HB90-6LT,
ROUND-1SP
SENSA-M, SENSA-P, SENSA-R35M, SENSA-R35P, SENSA-R35T, SENSA-T,
TOUCH-1, TOUCH-1CCT, TOUCH-1DIM, TOUCH-1SP, TOUCH-1L , TOUCH-1RGBW, TOUCH-3C, TOUCH-4DIM, TOUCH-CFU
COMPATIBLE MULTIFUNCTIONAL TRANSMITTERS
Tab. 4.1b
HB80-6G,
MCU-TX4,
TOUCH-1G, TOUCH-2G, TOUCH-4G, TOUCH-LOCK4, TOUCH-TX2,
ROUND-1G
COMPATIBLE GENERIC TRANSMITTERS (WIRELESS BUS)
