NEXTLED Stax Manuale utente
FRONT ACCESS
INSTALL & SERVICE GUIDE
2
4
6
9
12
13
15
17
20
PARTS LIST
ELECTRICAL, DATA WIRING, FCC COMPLIANCE
WIRELESS / LAN INSTALLATION
SOFTWARE SERVER CONNECTION
COMPONENT GLOSSARY
MODULE REMOVAL / REPLACEMENT
RECEIVING AND CONTROL BOX
TABLE OF CONTENTS
P: 833.474.STAX
E:
S
M
WWW.STAXLED.CO
M
3
LAY OUT THE PARTS
BOXES
CABLE BAGS
Controller Cable Kit(s) Power Continuation Cable Kit(s)
1 Primary Power Cable 20'
1 Primary Power/Data 20'
1 Power Boost 30'
Controller Box
Module Box
4
FRAME
FRAME DOORS
1'x2' Frame Doors
2'x4' Frame(s)
1'x2' Frame(s)
2'x4' Frame Doors
*Frame doors come in left & right pairs
P: 833.474.STAX E:
S
TAXLED
@
NEXTLEDSIGNS.CO
M
WWW.STAXLED.CO
M
5
LAY OUT THE PARTS
WHAT'S IN A BOX
CONTROL BOX
CONTROL BOX KEY
ANTENNA MOUNTING BRACKET
LIGHT SENSOR MOUNTING BRACKET
MODULE KEY
"L" MOUNTING BACKETS (4)
SCREWS, LOCK WASHERS, WASHERS (16)
6
CONTROLLER BOX
MODULE MODULE CABLE
FRAME BOLTS 10MM (4)
FRAME NUTS (4)
FRAME BOLTS 12MM (2)
SQUARE METAL PLATE
P: 833.474.STAX
E:
STAXLED
@
NEXTLEDSIGNS
.
COM
WWW.STAXLED.COM
7
MODULE BOX
ASSEMBLY INSTRUCTIONS
FRAME
Bolt the frame together for the desired dimension of sign.
Horizontal first, then vertical second recommended.
Frame Bolts and Nuts are found in the box that is inside each Module Box.
Left horizontal frame bolt Right horizontal frame bolt Top vertical frame bolt Bottom vertical frame bolt
1OPEN MODULE BOX
8
MODULES ONTO FRAMES
Take the module out of its plastic bag.
Take the module key (red handle) out of the control box.
Insert the module into the frame insert the module key into the six module
keyholes on each module and turn counterclockwise until tight. There are
3 module keyholes approximately 1.5” from the top and 3 module keyholes
approximately 1.5” from the bottom.
Take out Module cable and wire according to the diagram found on the
website. Do this for all module cables. Make sure cables that are wired
between connected frames use the cable slot as seen in the diagram on the
right.
IMPORTANT: After every 12th module, per sign face, you must connect a
continuation cable from module 12 to module 13. You can find this cable in the
cord bag with the yellow tag entitled STAX Boost Power Continuation Cable.
IMPORTANT: The maximum amount on one 20A circuit is 24 modules.
IMPORTANT: 300 modules are the maximum number of modules per display.
1
2
OPEN MODULE BOX
CONFIGURE WIRING
P: 833.474.STAX
E:
S
TAXLED
@
NEXTLEDSIGNS.CO
M
WWW.STAXLED.CO
M
9
CONFIGURE WIRING
Example display layout shown. For any rectangular matrix configuration, installer must start connection
in the specific corner as indicated. All power/data cables between modules should follow the connection
pattern shown above. Find all layout patterns and connection diagrams online at staxled.com
Electrical data and load charts are provided with individual purchase order specifications and are available
online.
Larger displays will require an additional power/data continuation cable.
10
Indice
