RACK ASSEMBLY
NOTE: All NE, NEU and NEDG series are using the same rack. Even though the pictures
may not show exactly the model you purchased, the assembly procedures are the same.
NOTE: Leaving the bolts slightly loose until all of the bolts are in position will make
minor adjustments easier to make. Drive all of the bolts tight with a 10 lb-in torque at the
end.
1. Place BRKT-P2 open side downwards
with FEX nuts facing forward. NOTE:
This piece looks very similar to BRKT-
P1. It is important not to confuse the two.
BRKT-P1 has notches in the front and the
back while BRKT-P2 doesn't.
2. Place BRKT-P3 open side downwards
directly behind BRKT-P2 so that the FEX
nuts are on the sides. NOTE: Orientation
of this piece is important. The front side
should be labeled. If there is no label, the
front is distinguished from the rear by the
following: On the sides, the distance
between the ends and the first FEX nut is
unequal in the front and the back. The
front side has a longer distance between
the edge and the FEX nut than the back side.
3. Looking at the assembly from the front,
line up the High Voltage Module on top of
BRKT-P2 and BRKT-P3 in the FRONT, LEFT
corner. The front panel of the HV Module
should hang over the two bottom pieces.
Back side has a
smaller distance.
Front side has a
larger gap.
