Nokia M5122 Manuale utente

Nokia M5122

T66250

USER MANUAL

ADSL Bridgeā

ECopyright Nokia Networks Oy

C33874002SE_A0 1

Nokia M5122

ADSL Bridge

User Manual

C33874.21B0

02.11.2000

1 Introduction to Nokia M5122

Nokia M5122 is an ADSL bridge which enables high-speed Internet

access and LAN interconnection. It increases the capacity of the

already installed telephone lines used traditionally for telephone

services. M5122 enables high-speedconnections for homesandsmall

offices.

Figure 1 Nokia M5122

NokiaM5122allowsmultiplePCsequippedwitha10Base-TEthernet

interface to be connected to a remote network via a Digital Subscriber

Line Access Multiplexer (DSLAM) and an ATM access network. It

acts as a bridge between the Ethernet LAN and ADSL/ATM network

interfaces. An in-built 4-port hub allows easy home and small office

network installation.

Nokia M5122 User Manual

ECopyright Nokia Networks Oy C33874002SE_A0

2 Installing M5122

Before installing M5122, you may want to familiarise yourself with

the interfaces and indicator lights of M5122. From section 2.3, you

will find a step-by-step installation procedure, which shows the

physical installation of M5122.

2.1 Interfaces

M5122 has one ADSL line interface and four Ethernet interfaces

(10Base-T). It also has a Command Line Interface (CLI) for

management purposes. The ADSL line interface is compatible with

ITU-T G.992.1 specification.

ADSL line (DSL)

Ethernet ports

(ETH-1, ETH-2,

ETH-3, ETH-4)

Command line interface (CLI)

Mains connector

Power switch

Figure 2 M5122 back panel

2.2 Indicator lights

M5122 has eight indicator lights on the front panel: PWR, STA, COL,

ETH-1, ETH-2, ETH-3,ETH-4, and DSL.STA indicator is red. Other

indicators are green.

ECopyright Nokia Networks Oy

C33874002SE_A0 3

Figure 3 M5122 front panel indicators

DSL GREEN

Off ADSL link is down.

Blinks ADSL connection is being established.

On ADSL link is up.

ETH- GREEN

Off Ethernet is down.

On 10Base-T Ethernet is functional.

Blinks Receives traffic from Ethernet.

COL GREEN

Blinks Collisions on the Ethernet. Note, that it is normal that some

collisions occur on the Ethernet.

STA RED

Off OK

On Hardware malfunction during startup.

PWR GREEN

Off Power off.

On Power on.

Nokia M5122 User Manual

ECopyright Nokia Networks Oy C33874002SE_A0

2.3 Step-by-step installation procedures

In this section, we present two installation procedures: ADSL data

servicesandTelephoneandADSLdataservices.Tousebothtelephone

and ADSL services, you will need a POTS splitter. This manual gives

installation example for a Nokia splitter T66270.

In these examples, we assume that you have installed your Ethernet

card properly and that your service provider has provided you with

instructions how to set your PC’s networking options.

ADSL data services

1. 2.

4. 5.

Figure 4 M5122 with cables connected (ADSL services only)

1. Plug the mains power cord to a mains outlet. M5122 can be

connected to an earthed socket outlet only.

2. SwitchonM5122.ThePWRindicatorlightsup.After awhile,the

red STA indicator blinks and then remains unlit. M5122 is now

functional.

3. Connect the Ethernet cable between your PC’s 10Base-T

connector and the Ethernet connector on the M5122 back panel

(ETH-1, ETH-2, ETH-3, or ETH-4).

4. Switchonyour PC. The indicatorcorresponding the Ethernet port

you connected your PC to becomes green when your PC has

started. This indicator blinks when there is traffic in the

corresponding Ethernet port.

ECopyright Nokia Networks Oy

C33874002SE_A0 5

5. Connect the ADSL line cable between the DSL connector on the

M5122 back panel and the wall socket. After a while, the DSL

indicatorstartsblinking.ThisindicatesthattheADSLlineisbeing

established. When the DSL indicator remains lit, the line is

functional.

6. Duringnormal operation PWR and DSL indicators are lit and the

Ethernetindicators of the active Ethernet ports blink or remain lit

dependingwhetherthereistrafficornot.COLindicatormayblink

occasionally during normal operation.

Nokia M5122 User Manual

ECopyright Nokia Networks Oy C33874002SE_A0

Telephone and ADSL data services with T66270 splitter

1.1.

4. 5.

Figure 5 M5122 with cables and splitter (T66270) connected

(Telephone and ADSL services)

1. Plug the mains power cord to a mains outlet. M5122 can be

connected to an earthed socket outlet only.

2. SwitchonM5122.ThePWRindicatorlightsup.After awhile,the

red STA indicator blinks and then remains unlit. M5122 is now

functional.

3. Connect the Ethernet cable between your PC’s 10Base-T

connector and the Ethernet connector on the M5122 back panel

(ETH-1, ETH-2, ETH-3, or ETH-4).

4. Switchonyour PC. The indicatorcorresponding the Ethernet port

you connected your PC to becomes green when your PC has

started. This indicator blinks when there is traffic in the

corresponding Ethernet port.

5. Connect the ADSL line cable between the DSL connector on the

M5122 back panel and the splitter’s MODEM connector.

6. Connect the splitter cable between the splitter’s LINE connector

and the wall socket. After a while, the DSL indicator starts

blinking. This indicates that the ADSL line is being established.

When the DSL indicator remains lit, the line is functional.

7. Connect the telephone to the splitter’s PHONE connector.

ECopyright Nokia Networks Oy

C33874002SE_A0 7

8. Duringnormal operation PWR and DSL indicators are lit and the

Ethernetindicators of the active Ethernet ports blink or remain lit

dependingwhetherthereistrafficornot.COLindicatormayblink

occasionally during normal operation.

NowyourM5122hasbeenconnectedandyoucanconfigureyourPC’s

networkingoptionsandcheckthattheserviceworksaccordingtoyour

service provider’s instructions.

2.4 Troubleshooting

This section gives some tips for troubleshooting.

Power (PWR) indicator is unlit.

Make sure that power cord has been connected to a mains outlet and

M5122 has been switched on.

Red status (STA) indicator is lit

Switch power off and then on again. If the STA indicator remains lit,

the unit may be faulty.

ADSL (DSL) indicator is unlit

Make sure that the ADSL line cable has been properly connected

between the DSL connector and the wall socket.

Ethernet (ETH-) indicator is unlit

Make sure that the Ethernet cable has been properly connected

between your PC’s Ethernet interface and the M5122 ETH connector.

Make sure that your PC is ON.

You cannot access the Internet

1. Make sure that your M5122 is ON.

2. Check that the DSL indicator is lit.

3. CheckthatEthernet indicator(ETH-1, ETH-2,ETH-3,orETH-4)

corresponding to the Ethernet interface you are connected to is

ON.

4. Make sure that your PC’s networking functions have been

configured according to your service provider’s instructions.

Nokia M5122 User Manual

ECopyright Nokia Networks Oy C33874002SE_A0

2.5 Installing M5122 on the wall

M5122 can also be wall mounted. Figure 6 shows the installation

procedure.

1. Drill two holes (6 mm in diameter) on the wall. The distance

between the holes must be 155 mm. Insert the plugs to the holes

and fix the screws.

2. Mount the modem on the wall as shown in Figure 6.

155 mm

6 mm

Figure 6 Wall installation

ECopyright Nokia Networks Oy

C33874002SE_A0 9

3 Configuring M5122

Your service provider has configured your M5122 for the service. Do

not change settings unless specifically asked by your service

provider. You can change M5122 settings with an ordinary web

browser, such as Microsoft Internet Explorer or Netscape Navigator.

UseaPCconnectedtoanETHportofM5122forconfiguration.Inthis

case the corresponding ETH indicator should be lit.

3.1 Browser management

The web configuration pages of M5122 can be accessed through the

Ethernetand through theADSL/ATM channels of M5122. In order to

access the web management feature, the IP functionality must be

activated and an IP address must be given to the corresponding

interface.

You can use your PC’s web browser software to access the web

configuration pages in M5122. To access the web pages you must

know the IP address of your M5122 or, alternatively, the “name”that

your M5122 recognises.

Note

Before using your web browser for configuration, you must know the

IP address or the name assigned to your M5122.

TherearethreewaystofindoutwhethertouseanameoranIPaddress:

DYour service provider has given you an IP address for M5122.

DYour M5122 uses DynamicHost ConfigurationProtocol(DHCP)

and Domain Name Server. In this case the name is M5122.

DYour M5122 uses DHCP. In this case run winipcfg.exe (Windows

95)oripconfig.exe(WindowsNT).TheIPaddressofM5122isthe

Default Gateway address shown by the ipconfig program.

3.1.1 Opening a connection

To open a connection to the Nokia M5122:

1. Start your web browser.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Nokia Hardware di rete

Nokia

Nokia IP350 - Security Appliance Manuale utente

Nokia

Nokia DNT2Mi-fp Manuale utente

Nokia

Nokia G-240W-J Manuale utente

Nokia

Nokia 7360 Intelligent Services Access Manager FX... Istruzioni per il montaggio

Nokia

Nokia ONT G-010G-P Manuale utente

Nokia

Nokia ONT XS-110G-A Manuale utente

Nokia

Nokia Beacon G6 Manuale utente

Nokia

Nokia 7302 Manuale utente

Nokia

Nokia G-211M-C Manuale utente

Nokia

Nokia 7750 SR Manuale utente

Nokia

Nokia 7368 ISAM ONT BGW320-505 Manuale utente

Nokia

Nokia ONT XS-2426X-A Manuale utente

Nokia

Nokia Flexi BTS Series Manuale utente

Nokia

Nokia 7368 ISAM ONT BGW320-505 Manuale utente

Nokia

Nokia IP560 - Hard Disk Drive Based Manuale utente

Nokia

Nokia B2 Manuale utente

Nokia

Nokia IP290 - Security Appliance Manuale utente

Nokia

Nokia 7302 Guida all'installazione

Nokia

Nokia 7368 ISAM ONT E-240G-B Manuale utente

Nokia

Nokia G-240G-E Manuale utente

Nokia

Nokia Flexi Zone Micro High Power 2x20 W BTS Manuale utente

Nokia

Nokia ONT G-010G-R Manuale utente

Nokia

Nokia 7368 ISAM ONT E-240W-A Manuale utente

Nokia

Nokia 7368 Manuale utente

Manuali Hardware di rete popolari di altre marche

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuale utente

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuale utente

Yudor

Yudor YDS-16 Manuale utente

D-Link

D-Link ShareCenter DNS-320L Manuale utente

Samsung

Samsung ES1642dc Istruzioni per l’uso

Honeywell Home

Honeywell Home LTEM-PV Istruzioni per il montaggio

evertz

evertz 7700 Series Manuale utente

D-Link

D-Link ShareCenter DNS-343 Manuale utente

Asante

Asante AsanteBridge 1012 Manuale utente

FireBrick

FireBrick FB2700 Manuale utente

Audiovox Electronics

Audiovox Electronics ARWH2T Manuale utente

ADC

ADC DSX-1 Manuale

NetComm

NetComm NF2 Manuale utente

Alcatel-Lucent

Alcatel-Lucent 5620 Manuale utente

Dell EMC

Dell EMC XC6420 Series Manuale utente

Lanner

Lanner NCA-1020A Manuale utente

Allied Telesis

Allied Telesis AT-TN121-A Manuale utente

Arista

Arista CCA-ETM-Q12 Manuale utente