5NookBox Installation Guide Ambient Light, Humidity and Temperature Sensor
Joining the ZigBee Network
As a ZigBee device, the sensor needs to join a ZigBee network to transmit signal. Please follow the steps below to join the sensor into the
ZigBee network.
The Light Sensor can only join ZigBee network within 3 minutes after power on.
1. Detach the Top Cover and Base assembly and insert battery.
2. Within 3 minutes after powering on, press and hold the function button for 10 seconds as the sensor resets (LED ashes once)
and starts searching for existing ZigBee network. Please make sure the permit-to-join feature on the router or coordinator of your
ZigBee network is enabled.
3. If the sensor successfully joins a ZigBee network, the LED Indicator will ash twice to conrm.
4. After joining the ZigBee network, the sensor will be registered in the network automatically. Please check your ZigBee coordinator,
system control panel or CIE (Control and Indicating Equipment) to conrm if joining and registration is successful.
5. After joining the ZigBee network, if the sensor loses connection with current ZigBee network, the LED will ash every 20 minutes
to indicate. Please check your ZigBee network condition and sensor signal range to correct the situation.
Removing Device from ZigBee Network (Factory Reset)
To remove the device from current ZigBee network, the Light Sensor must be put to Factory Reset to complete device removal. Factory Reset
function will clear the device of its stored setting information and prompt the device to search for new ZigBee network.
Before removing device, make sure the Light Sensor is within current ZigBee network signal range
1. Delete the Light Sensor from current control panel / CIE.
2. The device can only be reset within 3 minutes after power up. If the Light Sensor has been powered up for more than 3 minutes,
remove and reinsert the battery.
3. Press and hold the function button for 10 seconds, then release the button to reset device.
4. Upon reset, the Light Sensor will clear current ZigBee network setting and transmit signal to ZigBee coordinator to remove itself from
current ZigBee network. It will then actively search for available ZigBee network again and join the network automatically.
Installation
Mounting the Sensor
The sensor can be mounted using two methods: Self-adhesive or Screw mounting.
Self adhesive mounting
1. Clean the surface with a suitable degreaser.
2. Remove the protective covering from one side of double-sided adhesive pad and rmly apply to the back of the device.
3. Remove the other covering and rmly place/press the device in the desired location.
Do not use the Self-adhesive mounting method on poorly painted and/or rough surfaces.
Screw Mounting
The base of the sensor has two screw knockouts, where the plastic is thinner for mounting purposes. To mount the sensor:
1. Detach the Top Cover and Base assembly by loosening the Cover-Fixing Screw using a Philips screwdriver.
2. Break through the knockouts on the base.
3. Use the holes as a template to drill two holes and insert the wall plugs.
4. Screw the base into the wall plugs.
5. Replace the top cover over the base by hooking the base onto the xing hook and pushing the cover towards the base
6. Secure and screw the top cover back on to its base using a Philips screwdriver.
